When cells are placed in a hypotonic (low-salt) fluid, they can swell and burst. Meanwhile, cells in a hypertonic solution—with a higher salt concentration—can shrivel and die. How do fish cells avoid these gruesome fates in hypotonic freshwater or hypertonic seawater environments?

Fluorescence in situ hybridization, or FISH, was developed in the early 1980s and has quickly become one of the most widely used techniques in cytogenetics. Labeled probes are used to bind complementary DNA or RNA sequences on a chromosome or in a region within a cell. Earlier, the probes could only be obtained by cloning or reverse transcription of a DNA template. Currently, the probe oligonucleotides can be synthesized synthetically. Additionally, with the advancement of optical techniques,...

A thorough mouth assessment, including inspection and palpation of the lips, gums, tongue, tonsils, uvula, and pharynx, is crucial in detecting potential health issues. Diseases ranging from oral cancer to systemic conditions like diabetes could be identified early through careful oral examination. This article provides a detailed guide on conducting a comprehensive mouth assessment.
Mouth Inspection
The inspection begins with visually examining the mouth for symmetry, color, and size.

Plastic deformation represents a fundamental concept in materials science, which explains the irreversible change in the shape of a material when it experiences stress beyond its elastic capability. This phenomenon is important in structural engineering, especially in designing and analyzing cantilever beams—structures that are securely fixed at one end and bear loads at the opposite end. When these beams are subjected to loads within their elastic range, they will return to their...

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...