Related Experiment Video
Updated: Feb 11, 2026

Comparative Analysis of Lower Limb Kinematics between the Initial and Terminal Phase of 5km Treadmill Running
Published on: July 17, 2020
Running kinematics, spatiotemporal variation and lower limb strength at different stages of a 156-km ultra-trail race
Anh Phong Nguyen1,2, Jean-François Esculier1,3, Blaise Dubois1
1The Running Clinic, Lac Beauport, Canada.
Background:
Ultra-trail running is increasingly popular, yet most research on biomechanics focuses on road running or treadmills. This study assesses changes in foot strike pattern (FSP), step frequency, and other biomechanical parameters over a 156-km ultra-trail race.
Methods:
Fifty-five experienced runners participated in the Trail Scientifique de Clécy, a 156-km race with 6000 meters of elevation gain. Biomechanical data were collected at the end of each 26-km lap using video for FSP and Optojump for other parameters. Muscle strength was measured via maximal voluntary isometric contraction (MVIC) of the hip abductors and ankle plantar flexors.
Results:
Forty-one runners completed the race. FSP remained consistent. Step frequency decreased initially (P=0.003) before stabilizing. Self-selected speed declined by 14.2% (P<0.001), and step length reduced by 12.6% (P<0.001). Ground contact time increased (+12.9%, P<0.001), while flight time remained stable. Leg stiffness showed a non-significant decreasing trend (P=0.048). MVIC for hip abductors and ankle plantar flexors slightly decreased late in the race (P=0.015 and P=0.004).
Conclusions:
Experienced ultra-trail runners maintain consistent FSP while strategically adapting other biomechanical parameters to manage fatigue, supporting sustained performance and injury prevention in ultra-endurance races.
Related Concept Videos
What is Variation?
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
RACE - Rapid Amplification of cDNA Ends
Kinematic Equations - I
Wald-Wolfowitz Runs Test II
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
Variation
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...

