Application of slightly acidic electrolyzed water (SAEW) for surface disinfection in waste sorting and sewage
Marcin Cyprowski1, Bartłomiej Wróbel1, Anna Ławniczek-Wałczyk1
1Central Institute for Labour Protections - National Research Institute, Warsaw, Poland (Department of Chemical, Aerosol and Biological Hazards, Laboratory of Biohazards).
Objectives:
The objective of this study was to evaluate the effectiveness of surface disinfection using slightly acidic electrolyzed water (SAEW), concerning microorganisms detected in organic dust at a municipal waste sorting plant (WSP) and a sewage treatment plant (STP).
Material And Methods:
Five sampling sites were selected at each facility. Four disinfectants used in the tests included: SAEW solutions with active chlorine concentrations of 100 mg/l and 300 mg/l; a mixture of SAEW (100 mg/l) and silver nanoparticles (25 mg/l); and a commercially available disinfectant, a mixture of alcohols. Surface swab samples were collected to evaluate microbial contamination and compare bacterial and fungal levels after disinfection.
Results:
Analysis of the control samples (with no disinfectant application) revealed significant microbiological contamination of the surface tested. The tested disinfectants showed varying effectiveness against the microorganisms under study. For the aerobic and anaerobic bacteria, the highest decrease in concentrations was achieved when SAEW (300 mg/l) was applied. For the sampling sites in WSP, the log reduction values (LRV) were 2.32 and 1.99, respectively. For samples from the STP, the LRVs were 2.57 and 2.42. The most significant decrease in fungal concentration was induced by a commercial disinfectant made from a mixture of alcohols. For the samples collected at WSP, the LRV was 2.06, while for those from STP, it was 0.95. The lowest biocidal effectiveness was found for the preparation consisting of a mixture of SAEW and silver nanoparticles, for which the LRV values did not usually exceed 1.00.
Conclusions:
The results indicate that SAEW can be a promising alternative to the traditional alcohol-based disinfectants in occupational environments contaminated with organic dust. However, more comprehensive project should be conducted that would include a wider variety of work surfaces to be tested and a broader range of active chlorine concentrations. Int J Occup Med Environ Health. 2026;39(1):93-8.
More Related Videos
11:58Waste Water Derived Electroactive Microbial Biofilms: Growth, Maintenance, and Basic Characterization
Published on: December 29, 2013
09:49Use of a Battery of Chemical and Ecotoxicological Methods for the Assessment of the Efficacy of Wastewater Treatment Processes to Remove Estrogenic Potency
Published on: September 11, 2016
Related Concept Videos
Chemical Agents for Microbial Control
Cleaning, Sterilization, and Disinfection
Cleaning
The cleaning process usually involves using water with detergents or enzymatic cleaner and removing foreign material from objects and surfaces, including organic material such as body fluids or inorganic material like soil. Cleaning is performed before high-level disinfection and sterilization because foreign materials on the cover of the devices interfere with process...
Coagulation
Environmental Applications of Microorganisms
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Physical Methods for Controlling Microbial Growth: Radiation and Filtration
