Enhanced Mechanical and Surface Performance of Three-Dimensionally Printed Denture Base Resin via Zinc Oxide and...

The increasing adoption of digital light processing (DLP) three-dimensional (3D) printing in prosthodontics has enabled the rapid fabrication of denture bases with improved dimensional accuracy and reproducibility. However, the mechanical performance and surface characteristics of 3D-printed denture base resins remain inferior to those of conventional heat-polymerized polymethyl methacrylate (PMMA), limiting their long-term clinical reliability. This study aimed to investigate the effect of incorporating zinc oxide (ZnO) and samarium oxide (Sm₂O₃) nanoparticles, individually and as hybrid nanofiller systems, on the mechanical and wettability properties of a DLP 3D-printed denture base resin. ZnO and Sm₂O₃ nanoparticles were incorporated into a photopolymerizable denture base resin at concentrations of 1 and 2 wt.%, producing seven experimental formulations, including a control group. A total of 280 specimens were fabricated using a DLP 3D printer and subjected to standardized post-processing. Nanoparticle dispersion and morphology were examined using field-emission scanning electron microscopy (FE-SEM), while Fourier-transform infrared spectroscopy (FTIR) was employed to assess possible chemical interactions between the nanofillers and the polymer matrix. Mechanical performance was evaluated through impact strength, transverse strength, and flexural strength tests, and surface wettability was assessed using static water contact angle measurements. Statistical analysis was conducted using one-way ANOVA followed by Tukey's post hoc test (α = 0.05). The results demonstrated that all nanoparticle-reinforced groups exhibited significantly enhanced mechanical properties compared with the unmodified control resin. The incorporation of 1 wt.% nanofillers yielded the most pronounced improvements, with the 1 wt.% ZnO group achieving the highest transverse strength and the 1 wt.% ZnO-Sm₂O₃ hybrid group exhibiting the maximum flexural strength. Increasing the nanofiller concentration to 2 wt.% resulted in partial reductions in impact and flexural strength, which were attributed to nanoparticle agglomeration and increased light scattering during photopolymerization. FTIR analysis revealed no evidence of chemical bonding between the resin matrix and the nanofillers, indicating that the observed enhancements were primarily governed by physical reinforcement mechanisms. Wettability analysis showed that Sm₂O₃-containing formulations significantly reduced the water contact angle, indicating increased surface hydrophilicity, whereas ZnO incorporation produced more hydrophobic surfaces. Within the limitations of this in vitro study, the findings suggest that low-concentration incorporation of ZnO and Sm₂O₃ nanoparticles represents an effective strategy to enhance the mechanical integrity and tailor the surface properties of DLP 3D-printed denture base resins. These results suggest potential clinical relevance of nanoparticle-reinforced printed denture bases, emphasizing the importance of optimized filler loading to avoid agglomeration-induced performance degradation.