Every angle covered: OsWRKY36 regulates leaf inclination in rice
1Assistant Features Editor, The Plant Cell, American Society of Plant Biologists, USA.
The Plant Cell
|May 7, 2026
Summary
No abstract available in PubMed .
More Related Videos
Related Concept Videos
02:16Light Acquisition
In order to produce glucose, plants need to capture sufficient light energy. Many modern plants have evolved leaves specialized for light acquisition. Leaves can be only millimeters in width or tens of meters wide, depending on the environment. Due to competition for sunlight, evolution has driven the evolution of increasingly larger leaves and taller plants, to avoid shading by their neighbors with contaminant elaboration of root architecture and mechanisms to transport water and nutrients.
02:04Regulation of Transpiration by Stomata
During photosynthesis, plants acquire the necessary carbon dioxide and release the produced oxygen back into the atmosphere. Openings in the epidermis of plant leaves is the site of this exchange of gasses. A single opening is called a stoma—derived from the Greek word for “mouth.” Stomata open and close in response to a variety of environmental cues.
01:57Adaptations that Reduce Water Loss
Though evaporation from plant leaves drives transpiration, it also results in loss of water. Because water is critical for photosynthetic reactions and other cellular processes, evolutionary pressures on plants in different environments have driven the acquisition of adaptations that reduce water loss.
02:41Responses to Drought and Flooding
Water plays a significant role in the life cycle of plants. However, insufficient or excess of water can be detrimental and pose a serious threat to plants.
01:15Unsymmetric Bending - Angle of Neutral Axis
Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...
01:13Angle of Twist: Problem Solving
An electric motor applies a torque of 700 N·m to an aluminum shaft, triggering a stable rotation. Two pulleys, B and C, are subjected to torques of 300 N·m and 400 N·m, respectively. The modulus of rigidity is provided as 25 GPa. With the knowledge of the length and diameter of each segment, the twist angle between the two pulleys can be computed. First, a section cut is made between pulleys B and C, and the cut cross-section is analyzed using a free-body diagram. Given that the torque exerted...