Mechanical Performance of FDM-Printed PLA Joined by Portable Friction Stir Welding: Influence of Infill Density and...

This study evaluates the mechanical performance of FDM-printed poly(lactic acid) (PLA) structures joined using a portable Friction Stir Welding (FSW) device. A non-destructive optical band method was employed to assess weld homogeneity and material flow consistency. The influence of substrate infill density (15% and 100%) and tool pin geometry (cylindrical and truncated conical) was systematically analyzed. Results indicate that substrate density is the primary determinant of joint integrity; 100% infill specimens demonstrated superior structural homogeneity and consistent intensity profiles, whereas 15% infill specimens exhibited significant intensity fluctuations and poor consolidation, even with the addition of filler material. The mechanical evaluation revealed that the use of a tool pin is essential for effective load transfer, as specimens welded without internal agitation achieved only baseline tensile strengths of approximately 4 MPa. Among the pin-driven configurations, the cylindrical geometry outperformed the truncated conical design, reaching a peak tensile stress of 8.02 ± 1.42 MPa, corresponding to a joint efficiency of 27% relative to the 100% infill base material, compared to 6.25 ± 1.43 MPa. This performance gap is attributed to the cylindrical pin's ability to maintain higher shear rates and more uniform pressure distribution at the weld root. These findings demonstrate the feasibility of portable FSW for structural joining of additively manufactured polymers and establish critical processing parameters for the optimization of portable FSW in engineering applications.