Effect of Tempering Temperature on Microstructural Evolution and Mechanical Properties of Cr-Ni-Mo-V Steel for...

This study investigates the effects of tempering temperature on the microstructural evolution and mechanical properties of Cr-Ni-Mo-V steel designed for pressure vessel applications. The microstructure was characterized via scanning electron microscopy (SEM), transmission electron microscopy (TEM, Thermo Fisher Talos F200X), electron backscatter diffraction (EBSD), and physicochemical phase analysis. Mechanical performance was evaluated through tensile and impact tests, followed by a detailed discussion of the underlying strengthening mechanisms. The results demonstrate that the microstructure after tempering is fully tempered martensite. Samples tempered between 425 °C and 525 °C exhibit significant tempering resistance, maintaining a tensile strength of approximately 1300 MPa. This is primarily attributed to the synergistic effect of dislocation strengthening and the precipitation of MC-type carbides. As the tempering temperature increases to 625 °C, the dislocation density decreases sharply from 3.71 × 10¹¹ cm^-2 to 1.18 × 10¹¹ cm^-2, leading to a decline in strength. Concurrently, the impact energy increases significantly from 71 J to 132 J. The improvement in toughness is mainly attributed to the significant elevation of the crack initiation threshold, which is dominated by the reduction in matrix dislocation density, the coarsening and spheroidization of carbides, and the alleviation of local stress concentration. The relative proportion of high-angle grain boundaries (HAGBs, misorientation > 15°) increases from 51.9% to 57.7% during tempering, which is a result of the massive elimination of low-angle grain boundaries rather than an increase in the absolute length per unit area of HAGBs.