Related Experiment Video

Updated: Jun 7, 2026

Radio Frequency Magnetron Sputtering of GdBa2Cu3O7−δ/ La0.67Sr0.33MnO3 Quasi-bilayer Films on SrTiO3 (STO) Single-crystal Substrates
06:49

Radio Frequency Magnetron Sputtering of GdBa2Cu3O7−δ/ La0.67Sr0.33MnO3 Quasi-bilayer Films on SrTiO3 (STO) Single-crystal Substrates

Published on: April 12, 2019

The effect of yttrium addition on the ratcheting behavior of magnesium

Haoge Shou1,2, Yaoyao Song3, Yang Yang1

  • 1Zhumadian Central Hospital affiliated of Huanghuai University, Huanghuai University, Zhumadian, China‌‌.

Plos One
|June 5, 2026
PubMed

More Related Videos

Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition10:52

Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition

Published on: May 15, 2015

An Available Technique for Preparation of New Cast MnCuNiFeZnAl Alloy with Superior Damping Capacity and High Service Temperature14:51

An Available Technique for Preparation of New Cast MnCuNiFeZnAl Alloy with Superior Damping Capacity and High Service Temperature

Published on: September 23, 2018

Related Concept Videos

Complexation Equilibria: The Chelate Effect01:19

Complexation Equilibria: The Chelate Effect

In complexation reactions, metal atoms or cations interact with ligands to form donor-acceptor adducts called metal complexes. Ligands that bind through one donor site are monodentate, ligands with two donor sites are bidentate, and those with more than two donor sites are polydentate ligands. For example, ethylene diamine is a bidentate ligand that binds through two nitrogen donor atoms, forming a five-membered ring. EDTA is a polydentate ligand that binds through four oxygen and two nitrogen...
Common Ion Effect03:24

Common Ion Effect

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Châtelier’s principle. Consider the dissolution of silver iodide:
EDTA: Auxiliary Complexing Reagents01:26

EDTA: Auxiliary Complexing Reagents

EDTA titrations are usually carried out in highly basic conditions, where the fully deprotonated form of EDTA, Y4−, actively complexes with the free metal ions in the solution. Several metal ions precipitate as hydrous oxide (hydroxides, oxides, or oxyhydroxides) under these conditions, lowering the concentration of free metal ions in the solution. For this reason, auxiliary complexing agents or ligands such as ammonia, tartrate, citrate, or triethanolamine are used in EDTA titrations to...
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and reloaded.
Reaction Yield02:22

Reaction Yield

The theoretical yield of a reaction is the amount of product estimated to form based on the stoichiometry of the balanced chemical equation. The theoretical yield assumes the complete conversion of the limiting reactant into the desired product. The amount of product that is obtained by performing the reaction is called the actual yield, and it may be less than or (very rarely) equal to the theoretical yield.
Magnetic Damping01:17

Magnetic Damping

Eddy currents can produce significant drag on motion, called magnetic damping. For instance, when a metallic pendulum bob swings between the poles of a strong magnet, significant drag acts on the bob as it enters and leaves the field, quickly damping the motion.
If, however, the bob is a slotted metal plate, the magnet produces a much smaller effect. When a slotted metal plate enters the field, an emf is induced by the change in flux; however, it is less effective because the slots limit the...