Related Experiment Video
Updated: Jun 13, 2026

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry
Published on: February 2, 2018
Tracing Corrosive Damage in Human Teeth: A Forensic Pilot Study of Household Agents Using Stereomicroscopy, SEM-EDX
Larisa Adela Udriştioiu1,2, Marius Enăchescu3,4, Alexia Ecaterina Cârstea5
1Department of Legal Medicine and Bioethics, Faculty of Medicine, "Carol Davila" University of Medicine and Pharmacy, 050474 Bucharest, Romania.
Abstract:
Teeth may retain forensic value after chemical exposure, yet the effects of commercially available corrosive agents remain insufficiently characterized. This study evaluated short-term alteration patterns in human teeth exposed to household acidic and alkaline products available on the Romanian market. Five extracted mandibular third molars were analyzed, including four experimental teeth and one control. Each experimental tooth was fully immersed for 48 h in a different agent: hydrochloric acid descaler, sodium hypochlorite bleach, mixed hydrochloric/sulfuric acid descaler, or sodium hydroxide. Morphometric changes, mass, and pH were monitored serially, while stereomicroscopy, SEM-EDX, and hard tissue ground sections were used for structural and compositional assessment. Acid-exposed teeth showed the greatest damage, with major mass loss in the hydrochloric acid and mixed-acid samples, enamel loss, and marked microstructural disruption. The mixed-acid specimen exhibited the most severe collapse and near-complete calcium/phosphorus depletion. Sodium hypochlorite produced mainly superficial and root-level alterations with relative preservation of gross morphology, whereas sodium hydroxide caused minimal dimensional change and a calcium-rich adherent surface deposit. These findings show that household corrosives produce distinct, forensically recognizable dental alteration patterns within 48 h and support an integrated pattern-recognition approach in suspected chemical concealment scenarios.
More Related Videos
05:42Detection and Removal of Tooth-Colored Composite Resin Using the Fluorescence-Aided Identification Technique
Published on: July 27, 2022
07:42Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024