Machine Learning-Driven Design and Experimental Validation of a Highly Miniaturized Dual-Band MIMO Antenna for Sub-6...

The rapid expansion of sub-6 GHz 5G and Internet of Things (IoT) networks demands highly miniaturized Multiple-Input Multiple-Output (MIMO) antennas. However, balancing extreme physical compactness with rigorous inter-port isolation introduces severe computational bottlenecks for conventional optimization algorithms. To overcome these multidimensional challenges, this paper proposes a novel Deep Surrogate Active Learning framework for the autonomous design and empirical validation of an ultra-compact dual-band MIMO antenna. By using a surrogate-assisted closed-loop strategy to reduce reliance on repeated full-wave evaluations, the methodology combined a custom-penalized Deep Neural Network with dynamic boundary reduction. After training the initial surrogate model with 440 valid full-wave responses obtained from the offline design-of-experiments (DOE) stage, the best CST-validated candidate was identified at the 83rd active learning cycle. The optimized nested-loop geometry, incorporating a partial defected ground structure (DGS), occupies an extremely confined footprint of only 1634 mm² on a Rogers RO4350B substrate (Rogers Corporation, Chandler, AZ, USA). The selected geometry provided simulated -10 dB impedance bands of 3.35-3.88 GHz and 4.34-5.05 GHz, while the complete two-port model maintained inter-port isolation better than 13.8 dB and 14.9 dB across the lower and upper target passbands, respectively. Measurements of the fabricated prototype showed the intended dual-band behavior, a maximum measured gain of 4.54 dBi, and total radiation efficiencies of approximately 51-63% across both ports at the evaluated frequencies. The simulated Envelope Correlation Coefficient (ECC) remained below 0.035 across the target passbands, supporting the suitability of the compact geometry for the investigated sub-6 GHz MIMO bands.