Near-field acoustic holography with iteratively reweighted least squares-based outlier rejection and TV+ℓ1
William R Lippincott1, Robert J Malahowski1, Keith J Nowicki1
1Department of Physics, Northern Arizona University, Flagstaff, Arizona 86011, USA.
Abstract:
Near-field acoustic holography (NAH) reconstructs complex acoustic pressure fields from near-field microphone measurements. The equivalent source method (ESM), which relies on least squares inversion, is highly susceptible to measurement outliers. To address this, we present an ESM-NAH reconstruction approach, iteratively reweighted least squares (IRLS)-total variation (TV) and ℓ1 regularization (IRLS-TV+ℓ1), which employs bounded-influence M-estimation with IRLS to mitigate the impact of outlier-contaminated measurements. In addition, the method incorporates TV and ℓ1 regularization to capture both extended and compact source features. To evaluate performance, we simulate a piecewise-constant block source on a 16 × 16 grid at 25 dB signal-to-noise ratio (SNR), with 5% of channels corrupted by outliers. The proposed method achieves a reconstruction relative error of 4.4% under outlier contamination, compared to 4.3% for uncorrupted data. By comparison, Tikhonov regularization degrades from 15.9% to 96.3% relative error, sparse Bayesian learning (SBL) from 26.1% to 195% relative error, and the fused total generalized variation (F-TGV) benchmark from 7.8% to 168% relative error. Experimental measurements further indicate degradation factors of 11.5×, 14.0×, and 15.9× for Tikhonov, SBL, and F-TGV, respectively, under 5% introduced outlier contamination, whereas IRLS-TV+ℓ1 exhibits only a 1.02× increase.
Related Concept Videos
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear.
Residuals and Least-Squares Property
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length, the...
Calibration Curves: Linear Least Squares
For data that follow a straight line, the standard method for fitting is the linear...
Quantifying and Rejecting Outliers: The Grubbs Test

