Related Experiment Videos

A Blueprint for Developing a Concentration in Ambulatory Care Within the PharmD Curriculum

Helen Berlie1,2, Amber Lanae Martirosov1,3, Brittany Stewart1

  • 1Department of Pharmacy Practice, Eugene Applebaum College of Pharmacy and Health Sciences, Wayne State University, Detroit, Michigan, USA.

Related Concept Videos

Dosage Regimens: Designs and Approaches01:28

Dosage Regimens: Designs and Approaches

Designing a dosage regimen, which refers to the manner of drug administration, is a complex process involving the selection of drug dose, route, and frequency. This process is underpinned by pharmacokinetic parameters derived from tests and population averages. These parameters are then tailored to patient-specific variables such as diagnosis, demographics, and allergy status. Once therapy commences, therapeutic response monitoring is critical and achieved through clinical and physical...
Steady State Concentration01:05

Steady State Concentration

A steady state refers to the level of a drug in the body once it has reached an equilibrium between administration and elimination. It represents the point at which the drug administration rate equals the drug elimination rate, resulting in a relatively constant concentration in the body over time. The dynamic equilibrium is crucial to ensure the drug's effectiveness with minimal risk of toxicity.
Most drugs are administered in repeated doses at fixed intervals or through continuous intravenous...
Pharmacodynamic Models: Linear Concentration–Effect Model01:15

Pharmacodynamic Models: Linear Concentration–Effect Model

The linear concentration–effect model, underpinned by the principle that pharmacological effect (E) is directly proportional to plasma drug concentration (C), emerges as a pivotal simplification of the Emax model for conditions where C is significantly less than EC50. This model portrays a linear trajectory of the concentration–effect relationship when drug levels are markedly below the EC50 threshold.Despite its inherent assumption of continuous effect augmentation with increasing drug...
Drug Concentrations: Measurements01:23

Drug Concentrations: Measurements

Drug concentration is the quantity of a drug present in a biological sample. Measuring drug amounts in biological samples allows the clinician to understand how a drug is absorbed, distributed, metabolized, and excreted. Samples can be obtained through invasive or non-invasive methods. Invasive techniques involve surgical or parenteral interventions to gather blood, cerebrospinal fluid, or tissue biopsy. Conversely, non-invasive approaches provide samples like urine, feces, and saliva.
Plasma —...
Pharmacodynamic Models: Logarithmic Concentration–Effect Model01:15

Pharmacodynamic Models: Logarithmic Concentration–Effect Model

The log-linear model is a pharmacological framework used to describe the relationship between drug concentration and its effect. This model is particularly relevant when the observed effects range between 20% and 80% of the drug’s maximum effect (Emax), where a near-linear relationship is observed between the log of drug concentration and the measured effect. However, the log-linear model does not predict the maximum possible effect (Emax) or the effect at zero drug concentration, limiting its...
Pharmacokinetic–Pharmacodynamic Relationship: Problems01:24

Pharmacokinetic–Pharmacodynamic Relationship: Problems

The empirical approach to drug therapy optimization relies on correlating pharmacological response with administered dosage. Such an approach can be costly, time-consuming, and often yields poor correlation due to variables like formulation factors and drug elimination characteristics. A more precise approach correlates response with plasma drug concentration or the amount of drug in the body, rather than dosage. This is achieved through pharmacokinetic-pharmacodynamic (PK/PD) modeling, which...