Related Experiment Video
Updated: Feb 9, 2026

Assessment of Sensory Thresholds in Dogs Using Mechanical and Hot Thermal Quantitative Sensory Testing
Published on: October 26, 2021
Mechanism of reduced maximum expiratory flow in methacholine-induced bronchoconstriction in dogs
Abstract:
Airway sites of flow limitation ["choke points" (CP)] were identified during forced deflation in open-chest dogs before (C) and after (B) bronchoconstriction was produced by nebulizing a solution of methacholine chloride into their airways. CP were identified in two respective groups. In group I (n = 8) a retrograde catheter was used to locate CP and in the other a Pitot static tube (group II, n = 5), CP were identified at multiple lung volumes (VL) over the lower one-half of total lung capacity. Both groups showed similar findings at each condition. At B, corresponding values of maximum expiratory flow (Vmax) at each VL decreased to about 10% of those at C. Movement of CP relative to their original location varied at each VL and, especially at the lower VL, showed little peripheral movement. In group I, equal pressure points were also measured and were found to move peripherally at all the measured VL. In group II, cross-sectional area (A*) and airway compliance (K) at CP were estimated. During bronchoconstriction, A* decreased at the respective VL, and airways became less compliant. The reduction in Vmax could be explained in terms of changes in A* and K as described by wave-speed theory, and Vmax decreased because A* decreased. The decrease in A* was related in part to an increase in viscous pressure losses that reduced total pressure at CP and also in part to a change in the pressure-area behavior of bronchi at CP. Their relative effects on reducing A* and Vmax were examined.
Related Concept Videos
Maximum Power Flow and Line Loadability
Maximum Deflection
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
Mechanisms of Retrovirus-induced Cancers
Maximum Power Transfer
By substituting the entire circuit with...
Maximum Size of Aggregate
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.

