Rotating laminar emission camera with GE-detector: an analysis

Design criteria for a germanium detector emission camera with laminar collimator-detector geometry are reported. In this design, parallel plates above a grooved germanium slab form detector channels which accumulate data in multiple projections through 180 degrees. Activity distribution is determined through mathematical reconstruction from the projections. The laminar design has greater efficiency than a hole-collimated device due to a favorable open area ratio and due to collimation in only one dimension. The relative sensitivity at the center of the detector strip increases with detector length and distance from collimator face. Spatial resolution depends upon the design geometry (septal penetration and scatter within the crystal are of such small magnitude that degradation of the point spread function is minimal). A 30 channel protype device (ROLEC) shows good correlation with theoretically determined PSF and signal-to-noise ratio (SNR). Measuring times projected for a clinical sized device (300 mm diam) are about 4.6 times that of the Anger camera (with same SNR) and high resolution collimator.