Changes in gnathosonic and tooth contact characteristics induced by experimental occlusal interferences created using...

Occlusal sounds, contact timings and time moments were measured and analysed on 10 subjects onto whom an occlusal interference was created experimentally. A full-cast double crown was unilaterally set on the upper first molar of each subject, then gradually elevated for 0.06, 0.10, 0.20 and 0.30 mm by inserting a pre-calibrated metal folio. Occlusal sound was measured with an analyser designed for the purpose. Timings and time moments were analysed with a T-scan system. All measurements were performed at least 10 times per subject. The results showed that prolonged occlusal sound duration, changes in acoustic signal waveform and increased shift of the centre of effort were observed concomitantly with crown elevation. Differences in these values at 0.06 mm as compared with those at baseline were not statistically significant. This could be explained through a physiological compensation by the periodontal ligament. The differences with baseline were statistically significant from 0.10 mm ongoing. The distribution of occlusal conacts was determined by the use of a newly developed parameter. Referred to as 'Tap Score', the parameter consists of converting contact timings occurring in seven ranges into least-square-based weighted scores. Analysis of the tap score disclosed evident imbalance between the crowned and the non-crowned side starting from 0.10 mm elevation, whereby a forward shift of the major contact point was observed on the non-crowned side. Our study demonstrated that evident changes in gnathosonic and T-scan parameters are likely to occur at a crown elevation within a 0.06-0.10 mm range.(ABSTRACT TRUNCATED AT 250 WORDS)