In vitro fatigue fracture of an acrylic resin-based partial denture: an exploratory study

In this study the fatigue life of heat-cured acrylic resin test specimens shaped as maxillary partial dentures was examined. Ten test specimens were prepared from polymethyl methacrylate and were tested by a constant force fatigue test at 150 N immersed in +37 degrees C water. The fatigue-fracture surfaces of the test specimens were compared with a one-bend fracture surface of the control specimen by scanning electron microscopy. The correlation coefficient between the number of loading cycles required to cause fatigue failure in the midline section was calculated as was the concentration of residual methyl methacrylate. Results revealed that the fatigue life of the test specimens varied greatly (483 x 10(3) +/- 371 x 10(3) cycles) and that the correlation between the number of loading cycles and the midline section was poor (r -0.455). The correlation coefficient between the number of loading cycles and the concentration of residual methyl methacrylate was r 0.476 and p > 0.5. The fatigue-fracture surface of the test specimens was smoother in texture on the tension side than on the one-bend fracture surface.