Small cylindrical ultrasound sources for induction of hyperthermia via body cavities or interstitial implants

In this study, small (outside diameter 1 mm) cylindrical ultrasound sources were investigated for induction of hyperthermia in tumours. These ultrasound transducers could be placed in small-diameter body cavities, or they could be used interstitially in brachytherapy catheters. The ultrasound field measurements showed that the field is fairly uniform as a function of the length of the applicator except at the ends where sharp peaks were located. However, there were significant field variations as a function of rotation angle around the transducers. The degree of these non-uniformities varied from transducer to transducer, and also as a function of frequency. The temperature measurements in vitro perfused kidneys showed that therapeutic temperature elevations could be induced in perfused tissues. The radial extent of the therapeutic zone could be increased by circulating water around the applicators, thus avoiding high temperatures on the applicator surface. It was also shown that some control over the temperature distribution along the length of the applicator could be achieved by using a two-element applicator. An array of four applicators implanted in a square pattern with the spacing of 25 mm between the catheters, was able to heat the tissue volume inside of the implant. The results showed that these small ultrasound applicators may offer significant improvement over existing techniques by increasing the penetration depth and the control over the power deposition pattern.