[Effects of blowing or aspiration on ablation rate by excimer laser]

Accurate calibration of ablation rate by excimer laser prerequisite for precise photorefractive keratectomy (PRK). When a polymethylmethacrylate (PMMA) plate is ablated by excimer laser, debris is generated, which may affect homogeneity of the laser beam and energy density, and change the ablation rate. In order to clarify the effects of the debris on the ablation rate, we studied the changes in the ablation rate when the debris was removed by blowing or aspirating over the ablation area during PRK.PMMA plates were ablated using a scanning excimer laser system (EC-5000, NIDEK, Japan) in PRK mode under the following conditions: (1) with air blowing over the ablation area, (2) with aspiration of the debris, and (3) without treatment. The ablation rates were determined by measuring the refractive power of PMMA plates with a lens meter. The ablated surface was observed by scanning electron microscope (SEM). The ablation rate with blowing was the highest among the three conditions, that with aspiration was the second, and that without treatment was the lowest. The ablation rates with blowing showed no significant change when the ablation rates were changed. However, the ablation rates with aspiration or without treatment decreased as the pulse rate increased. The surface ablated during blowing was the smoothest in SEM photographs. We concluded that calibration of the ablation rate using PMMA plates must be done with appropriate air blowing.