Factors affecting cement strains near the tip of a cemented femoral component

A generic three-dimensional finite-element model of the upper half of the femur containing a cemented femoral stem of a total hip arthroplasty was developed to study those factors influencing cement strains near the tip of a cemented femoral component. This generic model was verified through another three-dimensional finite-element model that had been created based on the precise geometry of a cadaver femur implanted with a contemporary cemented femoral component. This cadaveric femoral reconstruction had been created with strain gauges embedded in the cement mantle and was then loaded under conditions simulating single leg stance and stairclimbing. By use of the cement strains measured experimentally in the cadaver femur, and comparison of them with those obtained from the finite-element model of that cadaver femur, it was possible to establish proper material properties, boundary conditions, and loading conditions for the generic model. The generic model was then modified parametrically to determine those factors that influence the strains occurring within the cement mantle near the tip of a cemented femoral component. These models suggest that the single factor that most adversely influenced peak strains at or near the tip of the prosthesis was a thin cement mantle. This effect was present both when the cement mantle was reduced in thickness and when a similar effect occurred by virtue of a varus or valgus placement of the stem. Factors that decreased the peak cement strains near the tip of the femoral stem included a more flexible stem and thicker cement mantles. This effect of a more flexible stem could be obtained by changing the modulus of the metal implant by uniformly reducing the thickness of the stem, or by tapering the stem within the same bone geometry. Thicker cement mantles reduced both the axial and the shear strains occurring at the tip of the prosthesis. The presence or absence of a hole in the tip of the prosthesis per se, as for a centralizer, had no significant effect on the peak cement strains seen around the tip of the prosthesis; however, truncating the tip of the prosthesis from a hemisphere to a flat profile, which resulted in a sharp corner at the tip of the prosthesis, produced a 35% increase in cement strains at the tip as a result of a stress concentration effect. Thus, the common way of modifying the tip to have a hole for a centralizer, which involved truncating the tip, increased the cement strains occurring near the tip of the prosthesis.