Three-dimensional computer-assisted stereotactic-guided microneurosurgery combined with cortical mapping of the motor...

TIM (Zeppelin Chirurgische Instrumente GmbH, 82 049 Pullach, Germany) is a tomographic imaging system which enables surgeons to visualize the pathologic lesions three dimensionally in relationship to the surrounding structures. The distance and the angle between the pathologic lesion and the anatomical and/or bony landmarks as well as the volume of the mass lesion can be measured. Therefore an accurate localization of the lesion is possible with this technique. It is very applicable for planning of surgery on skull base tumors. The surgical procedure for small and well-defined, intrinsic pathologic deep-seated brain lesions, however, becomes much easier by using the stereotactic techniques of this system. The target point and the direction brain-surface-to-lesion can be determined within seconds. Before the aiming probe is inserted to the target, the cortical motor area is mapped by direct electrical stimulation. The approach can be varied depending on the results of these neurophysiologic investigations of the brain surface. The dissection is made along the aiming probe up to the target point. Because of the fixation of the brain with the needle, a brain shifting due to the dissection as well as to CSF release is diminished. Forty patients with deep-seated intracerebral lesions were operated on during a 13 months period by these combined techniques in our service. Using this technique, we never made a negative exploration. In all but three patients, total removal of the mass lesion was achieved. Permanent neurological deficits were observed in two patients only. In our opinion, this combined imaging and neurophysiological technique is easy to perform, and of major benefit for the patients due to its accuracy and is preferable in comparison with other single computer localizer techniques without neurophysiological monitoring.