[Cold deformation elements for attaching an implantable hearing aid transducer to ear ossicles or perilymph]

Development and short-term implantation results of the Tübingen implantable hearing aid (TI = Tübingen implant) have been presented. The TI is designed for patients with sensorineural hearing loss due to a malfunction of the cochlear amplifier. This can be identified by the presence of positive recruitment and the absence of TEOAE (transitory evoked otoacoustic emissions). The Tübingen implant functions in two ways: it allows electronic amplification of the auditory signal and electromechanical signal transduction into a micromechanical vibratory stimulus. There are two paths by which vibratory stimulus reaches the cochlea: (1) directly through a perforation in the stapes foot plate into the perilymph or (2) via the ossicular chain. Made of pure titanium, the casing of the helium-tight welded transducer includes the piezoelectric actuator. An implantable manipulator device is designed for transducer positioning and anchoring in the mastoid cavity. Usually, the transducer probe tip is directly coupled to the body of the incus. This functions without a special coupling device by utilization of an Erbium-YAG laser. Special anatomical situations or the loss of incus and/or stapes suprastructure, however, requires coupling of the vibratory signal to other points of the ossicular chain or to the perilymph. A major problem, however, was an intraoperative, irreversible link between the titanium probe tip and coupling elements. To overcome this problem, the coupling elements were made of gold. A crimp technique was developed, allowing the surgeon to induce cold deformation of the gold. The cold deformation technique (crimp) results in an irreversible coupling between the titanium probe tip and the golden coupling element.