Sustained release of acetaminophen from heterogeneous matrix tablets: influence of polymer ratio, polymer loading,...

The aim of this research was to investigate the effect of pseudoephedrine (PE), polymer ratio, and polymer loading on the release of acetaminophen (APAP) from hydroxypropyl methyl cellulose (HPMC)/polyvinylpyrrolidone (PVP) matrices. Granules formulated with APAP or both APAP and PE, and various blends of HPMC and PVP were compressed into tablets at varying compression forces ranging from 2000 to 6000 Ib. In vitro drug release from the matrix tablets was determined and the results correlated with those of tablet water uptake and erosion studies. Drug release from the formulations containing both APAP and PE was slower than those containing only APAP (P < 0.05, F = 3.10). Drug release from tablets formulated with APAP only showed an initial burst at pH 1.16 or 7.45, and at high total polymer loading (> or = 9.6%). Formulations containing both APAP and PE showed slower drug release at pH 1.16 than at pH 7.45. At pH 1.16, a decline in the percentage of APAP released occurred after 18 hours. This was due to the hydrolysis of APAP to p-aminophenol. The drug dissolution data showed good fit to the Korsmeyer and Peppas model, and the values of the release exponents ranged from 0.20 to 0.62, indicating a complex drug release pattern. Tablet erosion studies indicated that the amount of APAP released was linearly related to the percentage of tablet weight loss. The kinetics of tablet water uptake was consistent with a diffusion and stress relaxation controlled mechanism. Overall, the results of this study indicated that PE, as a co-active in the formulation, modified the matrix, and hence retarded APAP release.