[Intrafemoral pressure measurement in different cement removal procedures during hip prosthesis replacement...

During primary hip arthroplasty an increase in intramedullary pressure (IMP) of up to 1000 mm Hg can be observed. As a result of this increased intrafemoral pressure, intramedullary constituents can pass into the venous circulation creating a risk of fat embolism syndrome (FES). In the present experimental study on 9 femora obtained from human corpses, we investigated the question as to whether various methods of cement removal during total hip revision arthroplasty are also associated with increased intramedullary pressure and a risk of FES. The IMP was recorded with a standardized experimental set-up during removal of cement from the proximal and distal regions, including removal of the cement "tip" and the intramedullary plug. The methods employed for this purpose included the osteotome and mallet, a compressed air powered chisel, and a modified intracorporal lithotripter. All the methods induced fluctuations in the IMP the highest values being recorded for the conventional method using the osteotome and mallet (45 mm Hg) and the lowest values for the intracorporeal lithotripter (7.5 mm Hg). Working on the distal cement caused higher fluctuations in comparison with the proximal region. The study failed to reveal any increase in mean IMP, and all measured values were in the low pressure range (considerably below 150 mm Hg). While there seems to be no apparent risk of an FES developing during removal of cement, careless manipulation of the distal cement plug may result in higher intrafemoral pressures--above 150 mm Hg--thus increasing the risk of a fat embolism syndrome.