Numerical study on the effect of steady axial flow development in the human aorta on local shear stresses in...

The three-dimensional flow through a rigid model of the human abdominal aorta complete with iliac and renal arteries was predicted numerically using the steady-state Navier Stokes equations for an incompressible. Newtonian fluid. The model adapted for our purposes was determined from data obtained from cine-CT images taken of a glass chamber that was constructed based on anatomical averages. The iliac arteries had a bifurcation angle of approximately 35 and a branch-to-trunk area ratio of 1.27. whereas the renal arteries had left and right branch angles of 40 and an area ratio of 0.73. The numerical tool FLOW3D (AEA Industrial Technology, Oxfordshire, UK) utilized body-fitted coordinates and a finite volume discretization procedure. Purely axial velocity profiles were introduced at the entrance of the model for a range of cardiac outputs. The four-branch numerical model developed for this investigation produced flow and shear conditions comparable to those found in other reported works. The total wall shear stress distribution in the iliac and renal arteries followed standard trends. with maximum shear stresses occurring in the apex region and lower shear stresses occurring along the lateral walls. Shear stresses and flow rate ratios in the downstream arteries were more effected by inlet Re than the upstream arteries. These results will be used to compare further simulations which take into effect the rotational component of flow which is present in the aortic arch.