The measurement of fringing fields in a radio-frequency hyperthermia array with emphasis on bolus size

The limited aperture size through which the em-field of the applicator is emanated and the constraining of this em-field near the bolus' edge is related to the appearance of superficial 'hot spot' phenomena in radiative hyperthermia. Regarding systems based on the concept of the annular phased array two questions arise: (1) what is the relative strength of the radial component present in the incident field of the radiators, and (2) in what way are fringing fields related to the bolus size? To address both of the above questions, the spatial distribution of the em-field emanated through the aperture of an applicator of the Amsterdam four waveguide-array system has been investigated for a long bolus and a short bolus. The em vector field emanated by the applicator has been characterized in two perpendicular planes, i.e. the aperture midplane and the sagittal midplane. It should be noted that this distribution depends on the propagation conditions throughout the coupling bolus, the phantom and other volumes attached, such as other applicators. Therefore two sets of propagation conditions have been measured: (1) the minimum number of parameters determining the propagation of the em-field namely one single waveguide, one bolus and a homogeneous phantom, and (2) the propagation conditions as for the clinical setting. It is stressed that the study concerns one specific radiative hyperthermia system, namely the AMC four-waveguide array, but that, based on the similarities discussed above, results may be extrapolated towards other radiative hyperthermia systems. According to the current study, bolus prolongation might lead to a clear clinical improvement, which is due to a decrease of the fringing field amplitude compared to the field amplitude in the centre of the aperture midplane. Bolus prolongation will lead to an extended heating area, the field lines being more aligned to the patient's main axis.