Related Experiment Video
Updated: Jul 12, 2026

A Simple Flight Mill for the Study of Tethered Flight in Insects
Published on: December 10, 2015
Maximal horizontal flight performance of hummingbirds: effects of body mass and molt
P Chai1, D L Altshuler, D B Stephens
1Department of Zoology, University of Texas, Austin, Texas 78712-1064. pengchai@aol.com
Abstract:
Hovering and fast forward flapping represent two strenuous types of flight that differ in aerodynamic power requirement. Maximal capabilities of ruby-throated hummingbirds (Archilochus colubris) in hovering and forward flight were compared under varying body mass and wing area. The capability to hover in low-density gas mixtures was adversely affected by body mass, whereas the capability to fly in a wind tunnel did not show any adverse mass effect. Molting birds that lost primary flight feathers and reduced wing area also displayed mass loss and loss of aerodynamic power and flight speed. This suggests that maximal flight speed is insensitive to short-term perturbations of body mass but that molting is stressful and reduces the birds' speed and capacity for chase and escape. Hummingbirds' flight behavior in confined space was also investigated. Birds reduced their speeds flying through a narrow tube to approximately one-fifth of that in the wind tunnel and did not display differences under varying body mass and wing area. Hence, performance in the flight tube was submaximal and did not correlate with performance variation in the wind tunnel. For ruby-throated hummingbirds, both maximal mass-specific aerodynamic power derived from hovering performance in low-density air media and maximal flight velocity measured in the wind tunnel were invariant with body mass.
More Related Videos
Related Concept Videos
Migration
Mate Choice
Optimal Foraging
Frequency-dependent Selection
Limits to Natural Selection
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...

