Nonmetals in the argon-inductively coupled plasma-optical emission spectrometry: I. Phosphorus, sulfur and carbon

The behavior of phosphorus, sulfur and carbon in the argon-ICP-OES was systematically investigated for a wide range of nebulizer gas flows and observation heights. Five lines of phosphorus, four lines of sulfur and three lines of carbon, which have analytical usable detection limits, were taken into consideration. The further parameter set was inspired by the needs of every-day-analysis in the laboratory, especially the low integration time that is necessary for analysis of large amounts of samples. For each element line a signal-to-noise plot was obtained with a method described earlier. The optimum conditions for the combined analysis were determined from signal-to-noise plots of those element lines with the lowest detection limits. The lowest detection limits for phosphorus (0.13 mg/L) and carbon (0.01 mg/L) are useful for solving many analytical problems. However, even the best detection limit for sulfur (2.97 mg/L) is only of limited use without further preconcentration. A major problem was the background of carbon, most probably from carbon dioxide, which increased the available detection limit to about 0.04 mg/L. Surprisingly, the best detection limits were obtained at very low observation heights, which were only a couple of millimeters above the load coil. Fortunately, all elements showed a similar behavior and so the detection limits at compromise conditions were only slightly higher compared with the single-element detection limits.