Measurement of canal occlusion during the thoracolumbar burst fracture process

Post-injury CT scans are often used following burst fracture trauma as an indication for decompressive surgery. Literature suggests, however, that there is little correlation between the observed fragment position and the level of neurological injury or recovery. Several studies have aimed to establish the processes that occur during the fracture using indirect methods such as pressure measurements and pre/post impact CT scans. The purpose of this study was to develop a direct method of measuring spinal canal occlusion during a simulated burst fracture by using a high-speed video technique. The fractures were produced by dropping a mass from a measured height onto three-vertebra bovine specimens in a custom-built rig. The specimens were constrained to deform only in the impact direction such that pure compression fractures were generated. The spinal cord was removed prior to testing and the video system set up to film the inside of the spinal canal during the impact. A second camera was used to film the outside of the specimen to observe possible buckling during impact. The video images were analysed to determine how the cross-sectional area of the spinal canal changed during the event. The images clearly showed a fragment of bone being projected from the vertebral body into the spinal canal and recoiling to the final resting position. To validate the results, CT scans were taken pre- and post-impact and the percentage canal occlusion was calculated. There was good agreement between the final canal occlusion measured from the video images and the CT scans.