A method for geometrical verification of dynamic intensity modulated radiotherapy using a scanning electronic portal...

In order to guarantee the safe delivery of dynamic intensity modulated radiotherapy (IMRT), verification of the leaf trajectories during the treatment is necessary. Our aim in this study is to develop a method for on-line verification of leaf trajectories using an electronic portal imaging device with scanning read-out, independent of the multileaf collimator. Examples of such scanning imagers are electronic portal imaging devices (EPIDs) based on liquid-filled ionization chambers and those based on amorphous silicon. Portal images were acquired continuously with a liquid-filled ionization chamber EPID during the delivery, together with the signal of treatment progress that is generated by the accelerator. For each portal image, the prescribed leaf and diaphragm positions were computed from the dynamic prescription and the progress information. Motion distortion effects of the leaves are corrected based on the treatment progress that is recorded for each image row. The aperture formed by the prescribed leaves and diaphragms is used as the reference field edge, while the actual field edge is found using a maximum-gradient edge detector. The errors in leaf and diaphragm position are found from the deviations between the reference field edge and the detected field edge. Earlier measurements of the dynamic EPID response show that the accuracy of the detected field edge is better than 1 mm. To ensure that the verification is independent of inaccuracies in the acquired progress signal, the signal was checked with diode measurements beforehand. The method was tested on three different dynamic prescriptions. Using the described method, we correctly reproduced the distorted field edges. Verifying a single portal image took 0.1 s on an 866 MHz personal computer. Two flaws in the control system of our experimental dynamic multileaf collimator were correctly revealed with our method. First, the errors in leaf position increase with leaf speed, indicating a delay of approximately 0.8 s in the control system. Second, the accuracy of the leaves and diaphragms depends on the direction of motion. In conclusion, the described verification method is suitable for detailed verification of leaf trajectories during dynamic IMRT.