Fibrinogen adsorption by PS latex particles coated with various amounts of a PEO/PPO/PEO triblock copolymer

Polystyrene (PS) latex particles of different sizes were adsorption coated with the polymeric surfactant Pluronic F108 (PEO129-PPO56-PEO129). The commercial surfactant was found to have a bimodal molecular weight distribution. However, the maximum surface concentrations resulting from adsorption of either the purified high molecular weight component or the composite were identical. An increase in the copolymer surface concentration on 252-nm particles was found to decrease their fibrinogen uptake exponentially. At maximum copolymer surface concentration, the fibrinogen uptake was two orders of magnitude lower than that of bare particles (down from 3.3 mg/m2 to 0.03 mg/m2). This surface protection was equally effective whether the adsorption involved the bimodal polymer surfactant or the purified high molecular weight fraction. The PEO tail mobility was investigated with electron paramagnetic resonance (EPR), and found to increase with an increase in polymer surface concentration. The comparatively slow motion of the PEO chains at low surface concentration indicated that not only the PPO block, but also the PEO blocks interacted hydrophobically with the PS surface. When the copolymer surface concentration was increased, the PEO tails were gradually being released, acquiring higher mobility as the surface became covered by the more strongly binding PPO blocks. Results obtained with F108 coated particles of different sizes showed that particle size had a significant effect on the fibrinogen uptake, with larger particles showing larger fibrinogen uptakes.