Related Experiment Video
Updated: Aug 11, 2026

Application of 3D Printing in the Construction of Burr Hole Ring for Deep Brain Stimulation Implants
Published on: September 7, 2019
Dual-floor burr hole adjusted to burr-hole ring and cap for implantation of stimulation electrodes. Technical note
Takamitsu Yamamoto1, Yoichi Katayama, Kazutaka Kobayashi
1Department of Neurological Surgery, Nihon University School of Medicine, Tokyo, Japan. nusmyama@med.nihon-u.ac.jp
Abstract:
Using a new perforator, the authors have developed a new dual-floor burr-hole method for use in deep brain stimulation therapy. The modification is called "dual-floor" because the usual 15-mm-diameter burr hole, which is located centrally and reaches the dura mater, is surrounded by a 4-mm-wide rim that is also planed downward by the new perforator to a depth of 4 mm. This dual-floor burr hole is adjusted to fit the burr-hole ring and cap that are are supplied by the electrode manufacturer. Such a method eliminates bulging of the scalp just over the burr-hole ring and cap. In addition, it is helpful for securing a tight fixation between the burr-hole ring and the skull.
More Related Videos
06:54Performing Repeated Intraoperative Impedance Telemetry Measurements during Cochlear Implantation
Published on: August 4, 2023
08:42The DREAM Implant: A Lightweight, Modular, and Cost-Effective Implant System for Chronic Electrophysiology in Head-Fixed and Freely Behaving Mice
Published on: July 26, 2024