Related Experiment Video
Updated: Aug 29, 2026

Novel Triple-Loop Technique for Suturing TFCC Injuries without Transosseous Tunnel
Published on: May 23, 2025
Forearm and elbow injury: the influence of rotational position
Joseph C McGinley1, Brendon C Hopgood, John P Gaughan
1School of Medicine, Temple University, 3400 North Broad Street, Philadelphia, PA 19140, USA.
Background:
The purpose of this study was to develop an axial loading forearm fracture model and to determine the influence of forearm rotation on the fracture pattern.
Methods:
Twenty-six cadaveric arms were thawed in saline solution. Pressure-sensitive film was sealed and was placed through a lateral arthrotomy into the radiocapitellar joint. The arm was potted at the proximal part of the humerus with the elbow in extension. Rotational range of motion was measured with use of a goniometer starting from a supinated position (0 degrees ). Specimens were placed in a vertical position at various angles of forearm rotation, and a 27-kg mass was raised to 90 cm and was dropped onto the distal part of the radius. The pressure film was removed and was analyzed to determine the radiocapitellar joint contact area following impact. Each arm was dissected, and the injury pattern was assessed.
Results:
Both-bone forearm fractures (proximal radial fractures with concomitant distal ulnar fractures) occurred at 5 degrees +/- 2.6 degrees of rotation, isolated radial head fractures occurred at 44.4 degrees +/- 5.2 degrees of rotation, and Essex-Lopresti fractures (radial head fractures with tearing of the interosseous membrane) occurred at 70 degrees +/- 25.2 degrees of rotation. The distribution of Essex-Lopresti and radial head fractures was significantly different at a cutpoint of 54 degrees of forearm rotation (p = 0.009), and the distribution of radial head fractures and both-bone forearm fractures was significantly different at a cutpoint of 10 degrees of forearm rotation (p = 0.001). The percent contact area of the radial head varied with the injury pattern (p = 0.029). Marginal radial head fractures occurred at 46.7 degrees +/- 6.6 degrees of rotation with a contact area of 30.9% +/- 8.6%, while comminuted radial head fractures occurred at 74.4 degrees +/- 27.2 degrees of rotation with a contact area of 53.9% +/- 8.3%.
Conclusion:
The amount of forearm rotation at the time of axial load impact directly influenced the injury pattern. Furthermore, the radial head contact area and the fracture severity increased in pronation compared with supination.
Related Concept Videos
Bones of the Upper Limb: Radius
The radius has a nail-shaped head, and a short...
Muscles that Move the Forearm
Forearm Flexors
The biceps brachii, brachialis, and brachioradialis are forearm flexors. The biceps brachii is made up of two heads. Its long head originates at the supraglenoid tubercle of the scapula, whereas that of the short head is...
Bones of the Upper Limb: Ulna
Muscles that Move the Arm
The pectoralis major has two origins. Its clavicular head originates on the medial half of the clavicle. In contrast, the sternocostal head originates on the costal cartilages of ribs 1-6, the sternum, and the aponeurosis of the external oblique of the...
Muscles of the Forearm that Move the Hand and Fingers
Anterior Compartment
The anterior compartment muscles originate from the humerus. They primarily function as flexors and are also known as flexor muscles. They typically insert on the carpals, metacarpals, and phalanges. The superficial layer includes the flexor carpi radialis,...
Angle of Twist - Elastic Range