Related Experiment Video
Updated: Aug 20, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Hand washing compliance among retail food establishment workers in Minnesota
Paul B Allwood1, Timothy Jenkins, Colleen Paulus
1Division of Environmental Health, Minnesota Department of Health, St Paul, Minnesota 55121, USA. Paul.Allwood@state.mn.us
Abstract:
Inadequate hand washing by food workers is an important contributing factor to foodborne disease outbreaks in retail food establishments (RFEs). We conducted a survey of RFEs to investigate the effect of hand washing training, availability of hand washing facilities, and the ability of the person in charge (PIC) to describe hand washing according to the Minnesota Food Code (food code) on workers' ability to demonstrate food code-compliant hand washing. Only 52% of the PICs could describe the hand washing procedure outlined in the food code, and only 48% of workers could demonstrate code-compliant hand washing. The most common problems observed were failure to wash for 20 s and failure to use a fingernail brush. There was a strong positive association between the PIC being a certified food manager and being able to describe the food code hand washing procedure (odds ratio [OR], 5.5; 95% confidence interval [CI], 2.2 to 13.7), and there was an even stronger association between the PIC being able to describe hand washing and workers being able to demonstrate code-compliant hand washing (OR, 15; 95% CI, 6 to 37). Significant associations were detected among correct hand washing demonstration, physical infrastructure for hand washing, and the hand washing training methods used by the establishment. However, the principal determinant of successful hand washing demonstration was the PIC's ability to describe proper hand washing procedure. These results suggest that improving hand washing practices among food workers will require interventions that address PIC knowledge of hand washing requirement and procedure and the development and implementation of effective hand washing training methods.
Related Concept Videos
Handwashing III: During the Procedure and Post-Procedure Steps
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated.
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail paint...
Hand hygiene
Hand washing...
Standard Precaution
Hand hygiene is the most crucial means to prevent the transmission of disease. Employers are legally required to provide their workers with personal protective equipment (PPE) to minimize exposure or contact with...
Healthcare Associated Infections II: Preventive Measures
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...

