Close-coupling calculations of low-energy inelastic and elastic processes in 4He collisions with H2: A comparative...

The two most recently published potential energy surfaces (PESs) for the HeH2 complex, the so-called MR (Muchnick and Russek) and BMP (Boothroyd, Martin, and Peterson) surfaces, are quantitatively evaluated and compared through the investigation of atom-diatom collision processes. The BMP surface is expected to be an improvement, approaching chemical accuracy, over all conformations of the PES compared to that of the MR surface. We found significant differences in inelastic rovibrational cross sections computed on the two surfaces for processes dominated by large changes in target rotational angular momentum. In particular, the H2(nu=1,j=0) total quenching cross section computed using the BMP potential was found to be a factor of 1000 larger than that obtained with the MR surface. A lesser discrepancy persists over a large range of energies from the ultracold to thermal and occurs for other low-lying initial rovibrational levels. The MR surface was used in previous calculations of the H2(nu=1,j=0) quenching rate coefficient and gave results in close agreement with the experimental data of Audibert et al. which were obtained for temperatures between 50 and 300 K. Examination of the rovibronic coupling matrix elements, which are obtained following a Legendre expansion of the PES, suggests that the magnitude of the anisotropy of the BMP potential is too large in the interaction region. However, cross sections for elastic and pure rotational processes obtained from the two PESs differ typically by less than a factor of 2. The small differences may be ascribed to the long-range and anharmonic components of the PESs. Exceptions occur for (nu=10,j=0) and (nu=11,j=1) where significant enhancements have been found for the low-energy quenching and elastic cross sections due to zero-energy resonances in the BMP PES which are not present in the MR potential.