Related Experiment Video
Updated: Aug 12, 2026

Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements
Published on: June 25, 2021
Discrimination of depth of sinusoidal amplitude modulation with and without roved carrier levels
Mark A Stellmack1, Neal F Viemeister, Andrew J Byrne
1Department of Psychology, University of Minnesota, Minneapolis, Minnesota 55455, USA. stell006@umn.edu
Abstract:
Thresholds for the discrimination of the depth of sinusoidal amplitude modulation with a broadband noise carrier were measured for three listeners in a two-alternative, forced-choice task for modulation frequencies of 8, 32, and 128 Hz. Thresholds were measured with the spectrum level of the carrier fixed at 20 dB across all trials and, separately, with the carrier spectrum level roved randomly over a 20-dB range (10-30 dB) in each interval. Mean thresholds were equal or slightly lower (but not significantly so) for the fixed conditions relative to the roved conditions, and the differences between thresholds were too small to be explained by assuming that listeners compared instantaneous intensity at corresponding phases of the modulation cycle (for example, in the troughs). Rather, it appears that listeners discriminated modulation depth by extracting an estimate of the modulation depth within each interval that was independent of the overall level. Consequently, models of envelope extraction must include normalization of the envelope fluctuations to the envelope dc.
Related Concept Videos
Graphical and Analytic Representation of Sinusoids
The first step is measuring the peak-to-peak value, which is twice the amplitude of the sinusoid. This provides information about the maximum voltage swing of the waveform.
Secondly, the period and angular frequency are determined. The period is the time taken for one complete cycle of the waveform, while...
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Difference from Background: Limit of Detection
The LOD indicates the presence or absence...
Receiver Operating Characteristic Plot
Exponential and Sinusoidal Signals
Sinusoidal Sources
In homes, the power supplies use sinusoidal sources to provide electricity. These sources generate a voltage that varies sinusoidally...

