Related Experiment Video
Updated: Aug 8, 2026

Enhanced Oil Recovery using a Combination of Biosurfactants
Published on: June 3, 2022
Basicity of some P1 phosphazenes in water and in aqueous surfactant solution
Lilli Sooväli1, Toomas Rodima, Ivari Kaljurand
1University of Tartu, Institute of Chemical Physics, Jakobi 2, 51014 Tartu, Estonia.
Abstract:
The pKa values in water and in dilute surfactant solution for 15 ring-substituted phenyl P1 pyrrolidino phosphazenes PhN=P(NC4H8)3 and the phenyl P1 dimethylamino phosphazene PhN=P(NMe2)3 previously studied in acetonitrile (AN) and tetrahydrofuran (THF) are reported. The nonionic surfactant Tween 20 was used for the basicity measurements of some compounds to overcome the solubility problems. Measurements with a control group of phosphazenes in both media were used to validate the use of the obtained pKa values as estimates of aqueous values. The pK(a) values of the studied phosphazenes in aqueous medium vary from 6.82 (2,6-dinitro-) to 12.00 (4-dimethylamino-). The basicity span is 5.18 pKa units. The aqueous pKa values of the P1 phosphazenes were correlated with the respective basicity data in AN and THF and from these correlations the pK(a) values in water for the parent compounds HN=P(NC4H8)3 and HN=P(NMe2)3 were estimated as 13.9 and 13.3. Also a comparison of the basicity of phosphazenes and some guanidines, amines and pyridines was made. In water the parent phosphazenes and guanidines are the strongest of all the groups of bases studied. In AN and THF the parent phosphazenes are clearly the strongest bases followed by guanidines, amines and pyridines which are bracketed between the basicities of phenyl phosphazenes. In the gas phase the phosphazenes for which data are available are clearly more basic than the other compounds referred to here. Comparison of the basicity data of P1 phosphazenes and some guanidines confirms earlier conclusions about the partly ylidic character of the N=P double bond.
Related Concept Videos
Surface Active Agents
Basicity of Aliphatic Amines
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
Solvating Effects
Leveling Effect and Non-Aqueous Acid-Base Solutions
The Leveling Effect of a Solvent
A generic acid (HA) reacts with the generic base (B-) to yield the corresponding conjugate base (A-) and conjugate acid (HB):
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.
Basicity of Heterocyclic Aromatic Amines

