1H and 13C NMR assignments and X-ray structures for three monocyclic benzoannelated dilactam polyethers

Gary L N Smith1, Susan S Alguindigue, Masood A Khan

  • 1Department of Chemistry and Biochemistry, University of Oklahoma, Norman, OK, USA.

Related Concept Videos

¹H NMR of Conformationally Flexible Molecules: Temporal Resolution00:52

¹H NMR of Conformationally Flexible Molecules: Temporal Resolution

At room temperature, the chair conformer of cyclohexane undergoes rapid ring flipping between two equivalent chair conformers at a rate of approximately 105 times per second. These two chair conformers are in equilibrium. The rapid ring flipping results in the interconversion of the axial proton to an equatorial proton and an equatorial to the axial proton. Such interconversions are too rapid and cannot be detected on the NMR timescale. Hence, the NMR spectrometer cannot distinguish between the...
Structure of Conjugated Dienes01:16

Structure of Conjugated Dienes

Introduction
Conjugated dienes are compounds characterized by the presence of alternating double and single bonds. In a conjugated system like 1,3-butadiene, the unhybridized 2p orbital on each carbon overlaps continuously, allowing the π electrons to be delocalized across the entire molecule. In contrast, this type of overlap does not occur in cumulated and isolated dienes, such as 2,3-pentadiene and 1,4-pentadiene, respectively. Instead, the π electrons remain localized between the double...
NMR Spectroscopy of Benzene Derivatives01:37

NMR Spectroscopy of Benzene Derivatives

Simple unsubstituted benzene has six aromatic protons, all chemically equivalent. Therefore, benzene exhibits only a singlet peak at δ 7.3 ppm in the 1H NMR spectrum. The observed shift is far downfield because the aromatic ring current strongly deshields the protons. Any substitution on the benzene ring makes the aromatic protons nonequivalent, and the protons split each other. The peak is, therefore, no longer a singlet and the splitting pattern and their associated coupling constants depend...
Nomenclature of Aromatic Compounds with Multiple Substituents01:11

Nomenclature of Aromatic Compounds with Multiple Substituents

When more than one substituent is present on the benzene ring, the IUPAC nomenclature depends on the number of substituents present.
For disubstituted benzene derivatives, with two groups attached to the benzene ring, three constitutional isomers are possible. For example, consider dimethyl benzene, often called xylene, where the second methyl group can be substituted at the second, third, or fourth carbon. The relative position of the substituents is represented by prefixes ortho, meta, or...
Nomenclature of Carboxylic Acid Derivatives: Amides and Nitriles01:11

Nomenclature of Carboxylic Acid Derivatives: Amides and Nitriles

Naming Amides
The IUPAC and common names of amides are derived from the parent carboxylic acid, by replacing the suffix “oic acid” and “ic acid,” respectively, with “amide.” In the following example, the IUPAC name ethanamide is derived from ethanoic acid, and the common name, acetamide, is obtained from acetic acid.
Conformations of Cycloalkanes02:29

Conformations of Cycloalkanes

Adolf von Baeyer attempted to explain the instabilities of small and large cycloalkane rings using the concept of angle strain — the strain caused by the deviation of bond angles from the ideal 109.5° tetrahedral value for sp3  hybridized carbons. However, while cyclopropane and cyclobutane are strained, as expected from their highly compressed bond angles, cyclopentane is more strained than predicted, and cyclohexane is virtually strain-free. Hence, Baeyer’s theory that was based on the...