Characteristics of highway stormwater runoff

Younghan Han1, Sim-Lin Lau, Masoud Kayhanian

  • 1Department of Civil and Environmental Engineering, University of California, Los Angeles 90095-1593, USA.

Related Concept Videos

Conservation of Mass in Moving, Nondeforming Control Volume01:14

Conservation of Mass in Moving, Nondeforming Control Volume

Stormwater detention basins are essential in managing runoff during heavy rainfall, particularly in urban areas where impervious surfaces increase the risk of flooding. Understanding the conservation of mass in these systems allows engineers to optimize basin performance, balancing inflow, outflow, and water storage.
In the context of a detention basin, the conservation of mass states that the total mass of water entering the basin must equal the mass leaving the basin plus any accumulation of...
Design Example: Analyzing Capacity Contours for Flood Risk Assessment01:17

Design Example: Analyzing Capacity Contours for Flood Risk Assessment

Flood risk assessment involves careful planning and analysis to ensure the safety of communities near water retention structures. Capacity contours are a vital tool in this process, as they illustrate the potential spread of water at specific levels in a given area. In the context of building a bund across a small valley, these contours play a critical role in evaluating the safety of nearby residential areas.In this example, the bund is intended to store stormwater in the valley. The engineers...
Gradually Varying Flow01:29

Gradually Varying Flow

Gradually varying flow (GVF) in open channels describes situations where water depth changes slowly along the channel due to factors like non-uniform bed slope, channel shape variations, or obstructions. This flow type occurs when the depth adjusts gradually to balance gravitational forces, shear forces, and energy requirements, resulting in a low rate of depth change.Characteristics of Gradually Varying FlowGVF is commonly observed in natural streams, rivers, and canals, where flow depth...
Introduction to Types of Flows01:23

Introduction to Types of Flows

Fluid flows are categorized by dimensionality and behavior, with one-dimensional flow being the simplest form, where properties like velocity and pressure change only along a single axis. Water moving through straight pipes exemplifies this flow type, as variations in other directions are minimal. One-dimensional analysis helps simplify understanding such flows, focusing solely on changes along the pipe's length.
Two-dimensional flow involves changes in both length and height, as seen in air...
Design Example: Design of an Irrigation Channel01:27

Design Example: Design of an Irrigation Channel

Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
Characteristics of Fluids01:31

Characteristics of Fluids

Fluids differ from solids primarily in their molecular structure and stress response. Solids have tightly packed molecules with strong intermolecular forces, maintaining their shape and resisting deformation. In contrast, fluids have molecules spaced farther apart with weaker forces, allowing them to flow and deform easily.
Fluids, which include both liquids and gases, are substances that deform continuously under shearing stress. For example, water and oil are liquids with molecules that can...