Controlled degradation of multilayered poly(lactide-co-glycolide) films using electron beam irradiation

The ability to undergo predictable and controlled degradation allows biopolymers to release prescribed dosages of drugs locally over a sustained period. However, the bulk or homogeneous degradation of some of these polymers like poly(L-lactide) (PLLA) and poly(lactide-co-glycolide) (PLGA) work against a better controlled release of the drugs. Inducing the polymers to undergo surface erosion or layer-by-layer degradation could provide a better process of controlled drug release from the polymers. This study has demonstrated that surface erosion degradation of PLGA is possible with the use of a multilayer film system, with PPdlLGA [plasticized poly(D,L-lactide-co-glycolide) (PdlLGA)] as the surface layers and poly(L-lactide-co-glycolide) as the center layer. The use of the more hydrophilic PPdlLGA as the surface layer resulted in a faster degradation of the surface layers compared to the center layer, thus giving a surface erosion degradation effect. The rate of surface degradation could also be controlled with electron beam (e-beam) radiation, where e-beam irradiation was shown to alter the degradation time and onset of polymer mass loss. It was also shown that the more highly irradiated PPdlLGA surface layers had an earlier onset of mass loss, which resulted in a faster reduction in overall film thickness. The ability to control the rate of film thickness reduction with different radiation dose promises a better controlled release of drugs from this multilayer PLGA film system.