Related Experiment Video

Updated: Jul 7, 2026

Convergent Polishing: A Simple, Rapid, Full Aperture Polishing Process of High Quality Optical Flats & Spheres
13:07

Convergent Polishing: A Simple, Rapid, Full Aperture Polishing Process of High Quality Optical Flats & Spheres

Published on: December 1, 2014

Loose abrasive line-contact machining of aspherical optical surfaces of revolution

O W Fähnle, H van Brug, C J van der Laan

    Applied Optics
    |July 1, 1997
    PubMed

    More Related Videos

    Characterization of Surface Modifications by White Light Interferometry: Applications in Ion Sputtering, Laser Ablation, and Tribology Experiments11:47

    Characterization of Surface Modifications by White Light Interferometry: Applications in Ion Sputtering, Laser Ablation, and Tribology Experiments

    Published on: February 27, 2013

    Laser Micromachining for Polymer Surface Topography Design05:49

    Laser Micromachining for Polymer Surface Topography Design

    Published on: September 19, 2025

    Related Concept Videos

    Area of a Surface of Revolution01:29

    Area of a Surface of Revolution

    Surfaces of revolution are formed when a two-dimensional curve is rotated around an axis, producing a three-dimensional shape. This concept is used in engineering tasks like determining the surface area of a rocket nozzle, where precise calculations are critical for applying uniform heat-resistant coatings. When a curve is revolved about the x-axis, it sweeps out a continuous surface whose area must be calculated accurately to estimate material requirements.Approximating with Conical BandsTo...
    Contact Angle01:13

    Contact Angle

    When a solid is dipped inside a liquid, the liquid surface becomes curved near the contact. For some solid–liquid interfaces, the liquid is pulled up along the solid, while for others, the liquid surface is convex or depressed near the solid surface. This phenomenon can be explained using the concept of cohesive and adhesive forces.
    The adhesive force is the molecular force between molecules of different materials, that is, between the molecules of the solid and the liquid. The cohesive force...
    Residual Stresses in Circular Shafts01:10

    Residual Stresses in Circular Shafts

    In materials that exhibit elastic and plastic behavior, known as elastoplastic materials, residual stresses can accumulate when these materials experience plastic deformation. This deformation arises from either high levels of shearing stress or significant strains. Residual stresses are internal stresses that persist within a material after removing the external force causing deformation. This phenomenon is demonstrated when observing the behavior of a shaft under torque; notably, the shaft's...
    Design Example: Deciding Thickness of Lubricating Fluid in a Shaft01:23

    Design Example: Deciding Thickness of Lubricating Fluid in a Shaft

    Effective lubrication between a rotating shaft and its bearing housing is essential in rotating machinery to minimize friction, wear, and energy loss. With carefully controlled thickness and viscosity, the lubricant layer prevents metal-to-metal contact, ensuring smooth operation.
    To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
    Plastic Deformation in Circular Shafts01:20

    Plastic Deformation in Circular Shafts

    When materials are subjected to forces that surpass their yield strength, they undergo a process known as plastic deformation. This results in a permanent alteration or strain in their structure. This concept can be specifically applied to circular shafts, where the deformation leads to a change in its shape. The precise evaluation of this plastic deformation requires understanding the stress distribution within the circular shaft, which is achieved by calculating the maximum shearing stress in...