Thermal screening of facial skin arterial hot spots using non-contact infrared radiometry
Related Experiment Video
Updated: Jul 6, 2026
Quantitative Visualization and Detection of Skin Cancer Using Dynamic Thermal Imaging
Published on: May 5, 2011
E M Williams1, A I Heusch, P W McCarthy
1Faculty of Health, Sport and Science, University of Glamorgan, Pontypridd, CF37 1DL, UK. mwilli15@glam.ac.uk
Abstract:
Non-contact infrared thermometry of facial skin offers advantages over less accessible internal body sites, especially when considering mass screening for febrile infectious disease. The forehead offers an obvious site, but does not present an isothermic surface, as various small arteries passing close to the surface create 'hot-spots'. The aim of this study is to use non-contact infrared (IR) thermometry to determine the link between the temperature at specific facial skin sites and clinical body temperature. A sample of 169 asymptomatic adults (age range 18-54 years) was screened with IR thermometers (Braun Thermoscan proLT for auditory meatus (AM) temperature representing clinical body temperature, and a Raytek, Raynger MX for skin surface temperature). Peak IR skin temperature was measured over the course of each posterior auricular artery (PAA) and each superficial temporal artery (STA). In a sub-group (n = 54) the peak skin temperature of the forehead's metopic region (MR) was also recorded. There were no differences (P > 0.05) between the PAA and STA at 34.2 +/- 0.9 degrees C and 34.2 +/- 0.7 degrees C, respectively, which were 2.5 degrees C cooler than the AM temperature (36.7 +/- 0.5 degrees C, p < 0.001). Although there was no correlation between AM and PAA or STA there was a correlation (r2 = 0.63, p < 0.001) between PAA and STA. There were no asymmetric temperature differences between the left and right sides and males had warmer skin over the MR (F, 33.6 +/- 0.7 degrees C versus M, 34.4 +/- 0.6 degrees C, p < 0.001). Although a lack of correlation between either PAA or STA and AM was apparent in asymptomatics, further research in symptomatics is required to determine the usefulness of these measurements in mass screening of conditions such as fever.
Related Concept Videos
01:19Assessing Body Temperature - Temporal Artery
Step 1: Perform hand hygiene and don a fresh pair of gloves to prevent cross-infection and ensure patient safety.
Step 2: Explain the procedure to the patient to establish trust. Clear communication establishes trust with the patient, ensures they understand what to expect, promotes cooperation, and enhances comfort during the procedure.
Step 3: Assess the patient's forehead...
01:13Equipments Used to Measure Body Temperature
Glass-bulb Thermometer:
Glass-bulb thermometers are hollow glass tubes with a bulb tip containing liquid such as ethanol or mercury. Historically, glass bulb mercury thermometers were the standard device to measure body temperature. Today, mercury thermometers are prohibited in many countries due to the hazardous effects of mercury and the risk of exposure if the glass bulb breaks. In general,...
01:14Temperature Measurement Sites
Oral: When assessing oral temperature, the thermometer tip should be placed under the tongue in the posterior sublingual pocket. It offers accurate readings and can be...
01:14Assessing Body Temperature - Axilla
Step 1: Perform hand hygiene and put on clean gloves to maintain infection control and prevent cross-contamination.
Step 2: Prepare the patient by explaining the procedure to ensure understanding and cooperation. Ensure privacy, expose the axilla, and inform the patient that minimal movement is crucial for an accurate reading.
Step 3: Adjust the patient’s clothing to expose only the axilla. It minimizes...
01:27Assessing Body Temperature - Rectal
Follow these steps for rectal temperature assessment:
Step 1: Perform hand hygiene and don clean gloves to prevent cross-infection.
Step 2: Position the patient in a side-lying position to better visualize the rectal...
01:14Assessing Body Temperature - Oral
Step 1:
Start by practicing proper hand hygiene to prevent the spread of microorganisms.
Step 2:
Take the thermometer out of the charging unit, switch it on, and wait for the ready sign.
Step 3:
Gently slide the probe cover until a click is heard. This simple action prevents cross-contamination and ensures the correct placement of the probe cover.
Step 4:
Instruct the patient to open their mouth and place...