Related Experiment Video
Updated: Jun 30, 2026

3D Printed Porous Cellulose Nanocomposite Hydrogel Scaffolds
Published on: April 24, 2019
Porous composite scaffolds based on gelatin and partially hydrolyzed alpha-tricalcium phosphate
S Panzavolta1, M Fini, A Nicoletti
1Department of Chemistry G. Ciamician, University of Bologna, via Selmi 2, 40126 Bologna, Italy.
Abstract:
Porous composite scaffolds of varying compositions were prepared by freeze-drying gelatin foams containing increasing amounts of alpha-tricalcium phosphate (alpha-TCP), up to about 40 wt.%. Due to the presence of gelatin, a partial hydrolysis of alpha-TCP into octacalcium phosphate (OCP) occurs during foaming. As a consequence, the scaffolds contain both alpha-TCP and OCP, in relative amounts of about 74% and 26%, respectively, independent of the initial composition. In physiological conditions the inorganic component of the scaffolds undergoes a further hydrolysis as shown by the finding that after immersion in phosphate-buffered saline at 37 degrees C for 1 week the scaffolds contain poorly crystalline hydroxyapatite together with OCP. The scaffolds display a porous interconnected microstructure. The mean dimensions of the pores decrease from about 350 to about 170 microm as the inorganic phase content increases. Simultaneously, the mean values of the compression strength and Young's modulus increase. Stabilization of the scaffolds was obtained by using a natural, non-toxic, crosslinking agent, genipin, which significantly improves their mechanical properties.
More Related Videos
12:22Synthesis of Thermogelling Poly(N-isopropylacrylamide)-graft-chondroitin Sulfate Composites with Alginate Microparticles for Tissue Engineering
Published on: October 26, 2016
10:19Ceramic Omnidirectional Bioprinting in Cell-Laden Suspensions for the Generation of Bone Analogs
Published on: August 8, 2022