Related Experiment Video
Updated: Jun 23, 2026

Fabrication of Spatially Confined Complex Oxides
Published on: July 1, 2013
Microstructures, surface properties, and topotactic transitions of manganite nanorods
Tao Gao1, Frank Krumeich, Reinhard Nesper
1Centre for Materials Science and Nanotechnology and Department of Chemistry, University of Oslo, P.O. Box 1033, N-0315 Oslo, Norway. tao.gao@kjemi.uio.no
Abstract:
Manganite (gamma-MnOOH) nanorods with typical diameters of 20-500 nm and lengths of several micrometers were prepared by reacting KMnO(4) and ethanol under hydrothermal conditions. Synchrotron X-ray diffraction (XRD) reveal that the gamma-MnOOH nanorods crystallize in the monoclinic space group P2(1)/c with unit cell dimensions a = 5.2983(3) A, b = 5.2782(2) A, c = 5.3067(3) A, and beta = 114.401(2) degrees . Transmission electron microscopy shows that the gamma-MnOOH nanorods are single crystalline and that lateral attachment occurs for primary rods elongated along 101. X-ray photoelectron spectroscopy studies indicate that the surfaces of the gamma-MnOOH nanorods are hydrogen deficient and compensated by surface complexation. The Raman scattering spectrum features five main contributions at 360, 389, 530, 558, and 623 cm(-1) along with four weak ones at 266, 453, 492, and 734 cm(-1), attributed to Mn-O vibrations within MnO(6) octahedral frameworks. The structural stability of the gamma-MnOOH nanorods was discussed by means of in situ time-resolved synchrotron XRD. The monoclinic gamma-MnOOH nanorods transform into tetragonal beta-MnO(2) upon heating in air at about 200 degrees C. The reaction is topotactic and shows distinctive differences from those seen for bulk counterparts. A metastable, intermediate phase is observed, possibly connected with hydrogen release via the interstitial (1 x 1) tunnels of the gamma-MnOOH nanorods.

