Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Design Example: Capacitance Multiplier Circuit01:20

Design Example: Capacitance Multiplier Circuit

In integrated circuit technology, a capacitance multiplier is often utilized to produce a larger capacitance value when a small physical capacitance falls short. This is achieved by a circuit that multiplies capacitance values by a factor of up to 1000, such that a 10-pF capacitor can replicate the performance of a 100-nF capacitor.
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Multi-input and Multi-variable systems01:22

Multi-input and Multi-variable systems

Cruise control systems in cars are designed as multi-input systems to maintain a driver's desired speed while compensating for external disturbances such as changes in terrain. The block diagram for a cruise control system typically includes two main inputs: the desired speed set by the driver and any external disturbances, such as the incline of the road. By adjusting the engine throttle, the system maintains the vehicle's speed as close to the desired value as possible.
In the absence of...
Bus Impedance Matrix01:24

Bus Impedance Matrix

Calculating subtransient fault currents for three-phase faults in an N-bus power system involves using the positive-sequence network. When a three-phase short circuit occurs at a specific bus, the analysis uses the superposition method to evaluate two separate circuits.
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...
Vision01:24

Vision

Vision is the result of light being detected and transduced into neural signals by the retina of the eye. This information is then further analyzed and interpreted by the brain. First, light enters the front of the eye and is focused by the cornea and lens onto the retina—a thin sheet of neural tissue lining the back of the eye. Because of refraction through the convex lens of the eye, images are projected onto the retina upside-down and reversed.
Cell-matrix's Response to Mechanical Forces01:13

Cell-matrix's Response to Mechanical Forces

In animal cells, the extracellular matrix allows cells within tissues to withstand external stresses and transmits signals from the outside of the cell to the inside. The extracellular matrix is extensive, and its composition varies between different types of tissues. For example, the reticular fibers and ground substance make up the ECM in loose connective tissue, while collagen and bone minerals make up the ECM of bone tissue. 
Anchoring junctions mechanically attach a cell to the...
Anatomy of the Eyeball01:20

Anatomy of the Eyeball

The eye is a spherical, hollow structure composed of three tissue layers. The outer layer — the fibrous tunic, comprises the sclera — a white structure — and the cornea, which is transparent. The sclera encompasses some of the ocular surface, most of which is not visible. However, the 'white of the eye' is distinctively visible in humans compared to other species. The cornea, a clear covering at the front of the eye, enables light penetration. The eye's middle layer, the vascular tunic,...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Simple fixation and removal of dacryocystorhinostomy tube.

Eye (London, England)·2017
Same author

The importance of immunosuppression as risk and prognostic factor for periorbital non-melanoma skin cancers.

Eye (London, England)·2017
Same author

Anterior, extracanalar, cervical spine osteochondroma associated with DISH: description of a very rare tumor causing bilateral vocal cord paralysis, laryngeal compression and dysphagia. Case report and review of the literature.

European review for medical and pharmacological sciences·2014
Same author

Feasibility, safety, and preliminary proof of principles of autologous neural stem cell treatment combined with T-cell vaccination for ALS patients.

Cell transplantation·2012
Same author

[Children's eye care in Italy through data provided by "Let's see clear" campaign].

La Clinica terapeutica·2012
Same author

Adaptive noise smoothing filter for images with signal-dependent noise.

IEEE transactions on pattern analysis and machine intelligence·2011
Same journal

Gaussian-modulated continuous-variable quantum key distribution over 60 km fiber using an integrated silicon photonic receiver.

Optics letters·2026
Same journal

E2E-OCT: end-to-end joint learning model using optical coherence tomography images for vocal cord leukoplakia diagnosis.

Optics letters·2026
Same journal

Holographic generation of panoramic 3D scenes by concave ellipsoidal mirror reflection.

Optics letters·2026
Same journal

Dual-pilot phase recovery with pair-wise maximum-ratio combining for coherent PONs.

Optics letters·2026
Same journal

Mapping the whispering gallery modes of a CaF<sub>2</sub> disk resonator with half-tapered fibers to estimate the fundamental mode volume.

Optics letters·2026
Same journal

Quantitative estimation of deep-subwavelength scale via dark-field scattering axial energy concentration decay profiles.

Optics letters·2026
See all related articles

Related Experiment Video

Updated: Jun 20, 2026

Automated Visual Cognitive Tasks for Recording Neural Activity Using a Floor Projection Maze
11:15

Automated Visual Cognitive Tasks for Recording Neural Activity Using a Floor Projection Maze

Published on: February 20, 2014

Acousto-optic matrix-matrix multiplier.

D S Kalivas1, G Albanese, A A Sawchuk

  • 1Signal and Image Processing Institute, University of Southern California, Los Angeles, California 90089, USA.

Optics Letters
|September 12, 2009
PubMed
Summary
This summary is machine-generated.

A novel optical architecture for matrix-matrix multiplication is introduced, leveraging beam-modulation for high-speed parallel processing. The design

More Related Videos

Bringing the Visible Universe into Focus with Robo-AO
10:35

Bringing the Visible Universe into Focus with Robo-AO

Published on: February 12, 2013

Visualization of Amyloid &#946; Deposits in the Human Brain with Matrix-assisted Laser Desorption/Ionization Imaging Mass Spectrometry
09:31

Visualization of Amyloid β Deposits in the Human Brain with Matrix-assisted Laser Desorption/Ionization Imaging Mass Spectrometry

Published on: March 7, 2019

Related Experiment Videos

Last Updated: Jun 20, 2026

Automated Visual Cognitive Tasks for Recording Neural Activity Using a Floor Projection Maze
11:15

Automated Visual Cognitive Tasks for Recording Neural Activity Using a Floor Projection Maze

Published on: February 20, 2014

Bringing the Visible Universe into Focus with Robo-AO
10:35

Bringing the Visible Universe into Focus with Robo-AO

Published on: February 12, 2013

Visualization of Amyloid &#946; Deposits in the Human Brain with Matrix-assisted Laser Desorption/Ionization Imaging Mass Spectrometry
09:31

Visualization of Amyloid β Deposits in the Human Brain with Matrix-assisted Laser Desorption/Ionization Imaging Mass Spectrometry

Published on: March 7, 2019

Area of Science:

  • Optoelectronics
  • Computer Architecture

Background:

  • Matrix-matrix multiplication is a fundamental operation in scientific computing and artificial intelligence.
  • Existing electronic multipliers face limitations in speed and power consumption.

Purpose of the Study:

  • To present a new optical architecture for high-speed matrix-matrix multiplication.
  • To explore the potential of beam-modulation techniques for optical computing.

Main Methods:

  • The proposed architecture utilizes beam-modulation for parallel data processing.
  • A detailed analysis of the parallel structure's impact on speed is provided.

Main Results:

  • The optical architecture demonstrates potential for significantly faster matrix-matrix multiplication compared to electronic methods.
  • The parallel nature of the design is key to its high performance.

Conclusions:

  • The presented beam-modulation-based optical architecture offers a promising approach for accelerating matrix-matrix multiplication.
  • Further investigation into physical limitations is necessary for practical implementation.