Search research articles

ABOUT JoVE

Overview Leadership Blog JoVE Help Center

AUTHORS

Publishing Process Editorial Board Scope & Policies Peer Review FAQ Submit

LIBRARIANS

Testimonials Subscriptions Access Resources Library Advisory Board FAQ

RESEARCH

JoVE Journal Methods Collections JoVE Encyclopedia of Experiments Archive

EDUCATION

JoVE Core JoVE Business JoVE Science Education JoVE Lab Manual Faculty Resource Center Faculty Site

Terms & Conditions of Use

Related Concept Videos

Feedback control systems

Feedback control systems

Feedback control systems are categorized in various ways based on their design, analysis, and signal types.
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...

Effects of feedback

Effects of feedback

Feedback in control systems plays a critical role in shaping various operational parameters, extending beyond simple error reduction to influence stability, bandwidth, gain, impedance, and sensitivity. Understanding these effects requires examining a basic feedback system characterized by defined input, output, error, and feedback signals.
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...

Root Loci for Positive-Feedback Systems

Root Loci for Positive-Feedback Systems

The Hartley oscillator is a positive feedback system that sustains oscillations by feeding the output back to the input in phase, thereby reinforcing the signal. Positive feedback systems can be viewed as negative feedback systems with inverted feedback signals. In these systems, the root locus encompasses all points on the s-plane where the angle of the system transfer function equals 360 degrees.
The construction rules for the root locus in positive feedback systems are similar to those in...

Cascaded Op Amps

Cascaded Op Amps

Operational amplifiers (op-amps) are versatile electronic components that can be interconnected in a cascade - one after another in a linear sequence. This cascading is possible due to their infinite input resistance and zero output resistance, allowing them to maintain their input-output relationships even when connected in series.
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...

Bewley Lattice Diagram

Bewley Lattice Diagram

The Bewley lattice diagram, developed by L. V. Bewley, effectively organizes the reflections occurring during transmission-line transients. It visually represents how voltage waves propagate and reflect within a transmission line, making it easier to understand the complex interactions that occur.

SFG Algebra

SFG Algebra

In Signal Flow Graph (SFG) algebra, the value a node represents is determined by the sum of all signals entering that node. This summed value is then transmitted through every branch leaving the node, making the SFG a powerful tool for visualizing and analyzing control systems.
Each node in an SFG corresponds to a variable, and the interactions between nodes are represented by branches with associated gains. When multiple branches lead into a node, the value at that node is the sum of the...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by

Same author

Orthogonal polarization fiber gyroscope with increased stability and resolution.

Applied optics·2010

Same author

Enhancement of surface second harmonic generation with waveguides.

Applied optics·2010

Same author

Geometrical limitations in grating pair pulse compression.

Applied optics·2010

Same author

Variational analysis of optical waveguides with rectangular cross section.

Applied optics·2010

Same author

Gain saturation in distributed feedback lasers.

Applied optics·2010

Same author

Subpicosecond solitons in an actively mode-locked fiber laser.

Optics letters·2009

Same journal

Gaussian-modulated continuous-variable quantum key distribution over 60 km fiber using an integrated silicon photonic receiver.

Optics letters·2026

Same journal

E2E-OCT: end-to-end joint learning model using optical coherence tomography images for vocal cord leukoplakia diagnosis.

Optics letters·2026

Same journal

Holographic generation of panoramic 3D scenes by concave ellipsoidal mirror reflection.

Optics letters·2026

Same journal

Dual-pilot phase recovery with pair-wise maximum-ratio combining for coherent PONs.

Optics letters·2026

Same journal

Mapping the whispering gallery modes of a CaF<sub>2</sub> disk resonator with half-tapered fibers to estimate the fundamental mode volume.

Optics letters·2026

Same journal

Quantitative estimation of deep-subwavelength scale via dark-field scattering axial energy concentration decay profiles.

Optics letters·2026

See all related articles

Search research articles

Related Experiment Video

Updated: Jun 19, 2026

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Published on: February 4, 2018

Matching of distributed-feedback structures.

|October 2, 2009

Summary

This summary is machine-generated.

Distributed-feedback structures offer enhanced dispersion for soliton switching with nonlinear materials. Researchers investigated matching these structures to preceding and following uniform grating sections for optimal performance.

More Related Videos

Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior

Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior

Published on: April 13, 2016

Related Experiment Videos

Last Updated: Jun 19, 2026

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Published on: February 4, 2018

Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior

Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior

Published on: April 13, 2016

Area of Science:

Optics and Photonics
Materials Science

Background:

Soliton switching requires increased optical dispersion.
Distributed-feedback structures are potential candidates for achieving this dispersion.

Purpose of the Study:

To investigate the matching of distributed-feedback structures with uniform grating sections.
To assess the feasibility of these structures for future soliton switching applications.

Main Methods:

Analysis of distributed-feedback structures.
Investigating matching conditions with uniform grating sections of identical periodicity.

Main Results:

The study explores the matching requirements for distributed-feedback structures.
The proposed matching method is detailed for integration with uniform gratings.

Conclusions:

Distributed-feedback structures are promising for soliton switching with advanced nonlinear materials.
The developed matching technique may have broader applications in optical systems.