Related Experiment Video

Updated: Jun 16, 2026

Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction
10:36

Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction

Published on: May 20, 2018

Pressure and stress dependence of the refractive index of transparent crystals

B Bendow, P D Gianino, Y F Tsay

    Applied Optics
    |February 6, 2010
    PubMed

    More Related Videos

    Cooling Rate Dependent Ellipsometry Measurements to Determine the Dynamics of Thin Glassy Films09:32

    Cooling Rate Dependent Ellipsometry Measurements to Determine the Dynamics of Thin Glassy Films

    Published on: January 26, 2016

    Related Concept Videos

    Stress-Strain Diagram - Brittle Materials01:24

    Stress-Strain Diagram - Brittle Materials

    Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation rate, indicating that their breaking and ultimate strength are equivalent. Such materials also show lower strain levels at the point of rupture. The failure in brittle materials predominantly results from normal stresses, as evidenced by the rupture created along a surface perpendicular to the applied load. These materials do not display...
    Determination of Crystal Structures01:29

    Determination of Crystal Structures

    In the late 1800s, the revelation that light extended beyond visible wavelengths led to the discovery of X-rays by Wilhelm Roentgen. Recognized as high-energy electromagnetic radiation with short wavelengths, X-rays prompted exploration into their interaction with crystals. Max von Laue proposed in 1912 that the periodic arrangement of atoms, ions, or molecules in crystals would cause them to diffract X-rays, a hypothesis confirmed through experiments with copper sulfate and zinc sulfide...
    Law of Rational Indices01:29

    Law of Rational Indices

    The Law of rational indices is a fundamental principle in the field of crystallography. According to this law, the intercepts of a crystal face along the crystallographic axes (the three-dimensional axes along which a crystal is measured) can be expressed as either equivalent to the unit intercepts (a, b, c) or simple whole number multiples of them. These multiples are typically denoted as na, n'b, and n''c, where n, n', and n'' are simple whole numbers.To illustrate, consider a crystal with...
    Strain and Elastic Modulus01:15

    Strain and Elastic Modulus

    The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
    X-ray Crystallography02:18

    X-ray Crystallography

    The size of the unit cell and the arrangement of atoms in a crystal may be determined from measurements of the diffraction of X-rays by the crystal, termed X-ray crystallography.
    Diffraction
    Diffraction is the change in the direction of travel experienced by an electromagnetic wave when it encounters a physical barrier whose dimensions are comparable to those of the wavelength of the light. X-rays are electromagnetic radiation with wavelengths about as long as the distance between neighboring...
    Transformation of Plane Stress01:18

    Transformation of Plane Stress

    Studying stress transformation is essential in understanding how stress components within a material, like a cube under plane stress, change with rotation. This change is analyzed by considering a prismatic element within the cube. As the element rotates, the stress components acting on it—both normal and shearing stresses—change in magnitude and orientation. This change is quantified using trigonometric functions of the rotation angle, relating the forces acting on the rotated element's faces...