Related Experiment Video

Updated: Jun 16, 2026

Interview: Bioreactors and Surfaced-Modified 3D-Scaffolds for Stem Cell Research
08:06

Interview: Bioreactors and Surfaced-Modified 3D-Scaffolds for Stem Cell Research

Published on: May 21, 2008

Great act to follow. Interviews by Richard Staines and Adele Waters

Almie Mngadi, Jo Smith

    Nursing Standard (Royal College of Nursing (Great Britain) : 1987)
    |February 19, 2010
    PubMed
    Summary

    Two nurses competing for Nurse of the Year discuss their ward management work and its inherent challenges. Their insights highlight key aspects of nursing excellence and leadership in healthcare settings.

    More Related Videos

    A Flow Adhesion Assay to Study Leucocyte Recruitment to Human Hepatic Sinusoidal Endothelium Under Conditions of Shear Stress11:38

    A Flow Adhesion Assay to Study Leucocyte Recruitment to Human Hepatic Sinusoidal Endothelium Under Conditions of Shear Stress

    Published on: March 21, 2014

    Shallow Water (Paddling) Variants of Water Maze Tests in Mice07:47

    Shallow Water (Paddling) Variants of Water Maze Tests in Mice

    Published on: June 3, 2013

    Related Concept Videos

    States of Water01:23

    States of Water

    Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
    Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
    Wheatstone Bridge01:29

    Wheatstone Bridge

    An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
    Thus, for accurate resistance measurements, a...
    Actin Treadmilling01:18

    Actin Treadmilling

    Actin filaments undergo polymerization and depolymerization from either end. The polymerization and depolymerization rates depend on the cytosolic concentration of free G-actins. The polymerization rate is generally higher at the plus or barbed end, while the depolymerization rate is higher at the minus or pointed end. At a steady state, critical concentration describes the concentration of free G-actin monomers at which the polymerization rate at the plus end is equal to that of the...
    Introduction to Actin01:26

    Introduction to Actin

    Actin is a highly conserved cytoskeletal protein found abundantly in eukaryotic cells. It constitutes 10% weight of the total cellular protein in muscle cells, while in non-muscle cells, it is lower and makes up around 1–5 percent of the total cell protein. Actin found in the unicellular amoebae and complex multicellular animals is around 80% similar, demonstrating their conservation over a billion years of evolution.  Actin coding genes are conserved within species and across different species.
    Steady Flow of a Fluid Stream01:27

    Steady Flow of a Fluid Stream

    Consider a control volume, such as a pipe with solid boundaries, through which fluid flows and changes direction due to the impulse exerted by the resulting force from the pipe walls. In steady flow, the mass of fluid entering the control volume at a given time, t, with velocity v1, is equal to the mass leaving after infinitesimal time dt, with velocity v2.
    During this process, the momentum of the fluid within the control volume remains constant over the time interval dt. By applying the...
    Sound Waves01:01

    Sound Waves

    Sound waves can be thought of as fluctuations in the pressure of a medium through which they propagate. Since the pressure also makes the medium's particles vibrate along its direction of motion, the waves can be modeled as the displacement of the medium's particles from their mean position.
    Sound waves are longitudinal in most fluids because fluids cannot sustain any lateral pressure. In solids, however, shear forces help in propagating the disturbance in the lateral direction as well. Hence,...