Effects of rigidity of an internal fixation device. A comprehensive biomechanical investigation

Internal fixation with instrumentation often accompanies surgical fusion to augment spinal stability, provide temporary fixation while the surgical fusion mass unites, and enhance postoperative mobilization of a patient. Some surgeons, however, feel that the existing plate-screw designs are too rigid and are the primary cause of "iatrogenic" adverse effects clinically observed. A three-part study, involving in vitro experimental protocol, analytical finite-element-based models, and an in vivo canine investigation, was undertaken to study the role of decreasing rigidity of a device on the biomechanical response of the stabilized segments. Two alternatives--the use of one variable screw placement (Steffee plate [unilateral, 1VSP model]) as opposed to two VSP plates (bilateral, 2VSP model) and two VSP plates with polymer washers placed in between the integral nut and plate (2MVSP model)--were considered for achieving a reduction in the rigidity of the conventional VSP system. The load-displacement data obtained from the in vitro experiments and the stress distributions within the stabilized and intact models predicted by the finite-element models revealed that the unilateral VSP system is less rigid and is likely to reduce stress shielding of the vertebral bodies compared with the 2VSP model. The undesirable effects associated with the use of the 1VSP plate system are the presence of coupled motions due to the inherent asymmetry and the likely inability to provide enough rigidity for decompression procedures requiring a complete excision of the disc. The use of two MVSP plates overcomes these deficiencies.(ABSTRACT TRUNCATED AT 250 WORDS)