Ultrasound dynamic micro-elastography applied to the viscoelastic characterization of soft tissues and arterial walls

Quantitative noninvasive methods that provide in vivo assessment of mechanical characterization of living tissues, organs and artery walls are of interest because information on their viscoelastic properties in the presence of disease can affect diagnosis and treatment options. This article proposes the dynamic micro-elastography (DME) method to characterize viscoelasticity of small homogeneous soft tissues, as well as the adaptation of the method for vascular applications [vascular dynamic micro-elastography (VDME)]. The technique is based on the generation of relatively high-frequency (240-1100 Hz) monochromatic or transient plane shear waves within the medium and the tracking of these waves from radio-frequency (RF) echoes acquired at 25 MHz with an ultrasound biomicroscope (Vevo 770, Visualsonics). By employing a dedicated shear wave gated strategy during signal acquisition, postprocessed RF sequences could achieve a very high frame rate (16,000 images per s). The proposed technique successfully reconstructed shear wave displacement maps at very high axial (60 mum) and lateral (250 mum) spatial resolutions for motions as low as a few mum. An inverse problem formulated as a least-square minimization, involving analytical simulations (for homogenous and vascular geometries) and experimental measurements were performed to retrieve storage (G') and loss (G'') moduli as a function of the shearing frequency. Viscoelasticity measurements of agar-gelatin materials and of a small rat liver were proven feasible. Results on a very thin wall (3 mm thickness) mimicking artery enabled to validate the feasibility and the reliability of the vascular inverse problem formulation. Subsequently, the G' and G'' of a porcine aorta showed that both parameters are strongly dependent on frequency, suggesting that the vascular wall is mechanically governed by complex viscoelastic laws.