Competitive and Differential RT-PCR (CD-RT-PCR) for Measurement of Normalized Gene Expression Using Antisense...

Quantitative mRNA characterization by reverse transcription (RT) of RNA and subsequent polymerase chain reaction (PCR) (RT-PCR) is, compared to qualitative RT-PCR detection of RNA, more complicated because of two features inherent in in vitro amplification. First, during the exponential phase, minute differences in a number of variables can greatly influence reaction rates, with substantial effect on the yield of PCR products. Second, as a consequence of reaction components consumption and generation of inhibitors, the amplification enters a plateau phase. At this point, the reaction rate declines to an unknown level. Another source of errors in quantitative RT-PCR analysis lies in the determination of the amount of RNA to be analyzed for each sample. In small samples, the total amount of RNA may even be beyond the limit of detection. The sample loading problem can be solved by presenting the level of expression of the gene of interest in reference to a constitutively expressed gene. In a PCR, this can be done by the simultaneous amplification of two different genes in one reaction vessel, which was called differential PCR (1). However, in many cases, a quantitative PCR assay is desired that is internally controlled both for errors in comparison between samples and for the efficiency of the amplification reaction. To that end, a technique was devised that combines competitive PCR and differential RT-PCR by coamplification of two genes and their corresponding competitive templates (2). This chapter describes the working procedures for the complete assay called competitive and differential RT-PCR (CD-RT-PCR) and concomitant techniques.